Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Omega General Help / Re: Crank sensor

« on: 16 January 2009, 21:37:20 »

  ;)hi iv just done mine 2 weeks ago cost me £22.00 bit of a pig to do you have to tack of your aircon pump and engine bracket was a thingy to get to but runs fine now mine was a 2.0tr 16v on a w reg

2

Omega General Help / tick over

« on: 09 December 2008, 13:39:39 »

hi all i have a 2lt omega lpg starts ok on petrol then changes over ok but tickover sometimes idles erratic then cuts out starts ok again does it on petrol/lpg iv changed crank sensor any ideas please

3

Omega General Help / Re: omega w reg 2.0 cuting out help please

« on: 01 December 2008, 18:13:41 »

thanks il check it in morning

4

Omega General Help / Re: omega w reg 2.0 cuting out help please

« on: 01 December 2008, 17:57:20 »

  :-[hi thanks for reply when a got the car few weeks ago it was cuting out all the time then would start ok but got worse now fitted new crank sensor it lot beter now starts brill drive about 1 mile abour 30mph the engine cuts in and out eratic and the rev counter bounces up and down then cuts out totally turn key off and restarts fine and ok all day it dose this on gas or petrol has to be electrical car drives fine abit slugish puling away but think thats down to 2.0l in bigish car  

5

Omega General Help / omega w reg 2.0 cuting out help please

« on: 01 December 2008, 16:06:48 »

hi all newby on here can any one help iv got w reg 2.0 omega petrol/lpg had problems with stalling looked on here and look liked  crank sensor replaced it yesterday boy what a pig :ie aircon/power steering pump/braket never again 100% beter now on morning starts perfect do 1 mile then rev counter bouncers then cuts out turn key off then restarts brill and ot rest off day also on tick over some times idles up and down between 800 to 1500 rpm  then some times cuts out but starts fine anyone got any ideas please