1
Omega Electrical and Audio Help / phillps ccr2006
« on: 19 January 2009, 21:16:03 »
i have a ccr2006 and cd player comes up in safe mode anyone got ideas on how to fix and how much
- 28 October 2025, 11:30:46
- Welcome, Guest
News:
Please check the Forum Guidelines at the top of the Newbie section
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
2
Omega General Help / cats?
« on: 26 September 2010, 14:43:53 »
can i remove my cats off my car and pass mot??
3
Omega General Help / Re: help required please
« on: 23 September 2010, 18:20:07 »
it is looking like the cats are buggered then by the looks of it then 
4
Omega General Help / Re: help required please
« on: 22 September 2010, 22:28:18 »
Thanks for reply yes kept same throttle body and pleneum plug leads all connected when engine was out of car but will double check, the pipe which blew was on same side above air con pipe. don't think the cats are blocked as it runs fine when engine is cold,how can i check if they are blocked and how can i cure it if they are ? seems like there is plenty of pressure coming out or exhaust. many thanks for all your replys. i may sound stupid but what is the sai again 
am getting old and can be quite forgetfull 
am getting old and can be quite forgetfull
6
Omega General Help / Re: help required please
« on: 21 September 2010, 23:25:40 »
Bit of a update peeps, i took the pleneum off tonight and it stunk of petrol,i also found that it wasn'tsitting properly. all put back together but still have same problem ,i,ve also noticed that the chrome pipe in front of the drive belt gets red hot !! can any one explain why is this??? it has also blown the short rubber pipe it connects onto,could this be the problem??
7
Omega General Help / Re: help required please
« on: 15 September 2010, 21:01:15 »
just another thought would it cause it to do that if the vacum pipes were connected the wrong way ?
8
Omega General Help / Re: help required please
« on: 14 September 2010, 20:26:01 »
ok i know whatr you mean yes is connected it all run fine in doner car :-/
9
Omega General Help / Re: help required please
« on: 14 September 2010, 20:16:39 »
hi i,ve not got drive by wire throttle it is done by cables
10
Omega General Help / Re: help required please
« on: 14 September 2010, 18:57:43 »
as far as i know cant see that it will be sensors as ll good before
11
Omega General Help / Re: help required please
« on: 14 September 2010, 18:33:52 »
right guys i,ve been and read the codes think i did it right it goes 212129493947 hope someone will make sense of that 
ill also add that it will rev to 2000 rpm then drop to a thousand then back to 2000 lightg ondash stays on all the time
ill also add that it will rev to 2000 rpm then drop to a thousand then back to 2000 lightg ondash stays on all the time
12
Omega General Help / Re: help required please
« on: 12 September 2010, 09:22:00 »
all runs fine when cold it'just won't rev past 2500 when warm
13
Omega General Help / Re: help required please
« on: 11 September 2010, 23:12:01 »
i may sound thick but have tried reading them but cant seem to understand them. will try again on monday as the mig is not on my drive
14
Omega General Help / Re: help required please
« on: 11 September 2010, 22:49:08 »
didn't smell any burning of wires only oily smell which is normall after changing a engine
15
Omega General Help / Re: help required please
« on: 11 September 2010, 22:36:40 »
i kept same ecu on car for engine,i did think that it might be a crank or cam sensor. but why did it run ok while still ondoner car all wires are connected.