Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Omega Electrical and Audio Help / Error codes

« on: 02 April 2009, 11:29:55 »

Using the Auto Scanner Opel CAN I have the following error codes
 Which code to talcke first?

P1555: Throttle Position Sensor (TPS) Load Signal not Plausible with Engine Load - Not Present The control unit recognises the malfunction of the circuit via an internal evaluation logic.
Concerned Terminals:
3, 10, 13, 20, 26, 30, 42, 45, 58, 62 (X58)

P0170: Lean Exhaust - Present
Air/fuel mixture constantly too lean
Concerned Terminals:
19 (X58), 35 (X58), 57 (X58)

P0130: O2 Sensor 1 Circuit Voltage Low - Not Present
The voltage at the control unit input (terminal 57 (X58) ) is temporary too low.
The fault is stored directly on recognition.
Concerned Terminals:
19 (X58), 35 (X58), 57 (X58)

P0130: O2 Sensor 1 Incorrect Signal - Not Present
The control unit recognises the malfunction of the circuit via an internal evaluation logic.
Concerned Terminals:
19 (X58), 35 (X58), 57 (X58)

P0302: Cylinder 2 Misfire Detected - Not Present
Too many misfires detected by the crankshaft position sensor
Concerned Terminals:
31 (X58), 63 (X58)

This after removing the error codes

SVS-request from Transmission Control Module
Thanks Nigel

2

Omega Electrical and Audio Help / EMU

« on: 28 March 2009, 09:57:08 »

Just had a master reset but can tell engine not running right Have 2.2 auto omega  Not sure in what direction to go in  Nigel

3

Newbie Welcome Area / Omgega EMU

« on: 28 March 2009, 09:45:55 »

Just got my first omega 2.2 auto. All went well untill emu light came on. Ive had a master reset but can still tell something not right with the engine. Otherwise a great cr to drive
Regars Nigel