Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Omega General Help / Re: Code 0335 after Crank sensor change

« on: 20 August 2012, 11:48:03 »

Thanks for the Reply Jimbob,
No there was nothing showing when the car would not start and the check lamp was not on.
Code reader an Autel maxiscan MS509 and have used it to find a MAF fault previouly

2

Omega General Help / Code 0335 after Crank sensor change

« on: 20 August 2012, 11:40:55 »

Big bus broke down on sat. Just cut out. Did pedel trick and came up with 0335.
Restatred afer 10 mins but died again after 3 mins.
Got recoverd home and have replace the crankshaft sensor..(Genuine Vauxhall).
Car now runs fine but when I do pedel trick I still have 0335.
Put code reader on and nothing showing.(Car is 2.6 face lift.)
Anybody know if the 0335 will clear after a while.
Cheers

3

Omega General Help / Re: Quick Autobox Question

« on: 18 January 2010, 22:00:28 »

Thanks dbug but I cannot find anything on the gearbox but there is a 13mm bolt on the side of rear sump right up by the joint were it meets the gearbox casting.

4

Omega General Help / Quick Autobox Question

« on: 18 January 2010, 21:48:35 »

Just tryed to check the oil level on my 2001 2.6 auto, Is the filler/level hole on the rear sump on the drivers side at the top near the gearbox casting. I cannot find anything on the gearbox itself, also do I check the level with the engine running in neutral. Thanks

5

Omega General Help / GM V6 Cambelt markings

« on: 27 May 2009, 19:13:51 »

Just about to do the cambelt on my 2001 2.6 V6. Got the excellent DVD and a cambelt kit from the dealers on T/C. Problem is that there are no white markings on the belt to set it up like on the DVD is this a problem ?