1
Omega General Help / Re: 3.0 v6 starting problem
« on: 05 January 2013, 12:50:52 »
got it sorted it was a MAF thanks.
- 21 July 2025, 23:22:49
- Welcome, Guest
News:
Welcome to OOF
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1] 2
2
Omega General Help / Re: 3.0 v6 starting problem
« on: 03 January 2013, 00:28:04 »
yea lol it will start if i play with the throttle but will run rough and will stall when i let off the pedal
3
Omega General Help / Re: 3.0 v6 starting problem
« on: 03 January 2013, 00:24:40 »
engine is x30xe. no codes are stored and its a genuine sensor
4
Omega General Help / 3.0 v6 starting problem
« on: 03 January 2013, 00:20:21 »
hi my omega decided to stop engine management light was on ive changed the crank sensor and the light has went out tho still will not start anyone any ideas
5
Omega General Help / ex northern ireland cop 3.2 for breking
« on: 20 February 2010, 02:11:06 »
Content deleted!
6
Omega General Help / Re: My car thinks it's 68 degrees outside!
« on: 20 February 2010, 02:23:14 »
we wish lol
7
Omega General Help / Re: limp mode
« on: 20 October 2009, 15:23:38 »
lol i only use the omega for drifting in belfast 
8
Omega General Help / Re: limp mode
« on: 20 October 2009, 14:40:36 »
ok the only prob is most of the wires are the same colours
9
Omega General Help / limp mode
« on: 20 October 2009, 14:20:03 »
how do i bypass limp mode on my 3.2 as the wires r snapped on the exhausts as it drops p
alot of power i think :-/
alot of power i think :-/
10
Omega General Help / Re: alternator wires
« on: 15 October 2009, 02:06:27 »
after a few checks, the battery wasnt charging but when I connected the other car via jump leads got 13.9 so took off all connections, cleaned them took half my skin off with a wire brush ( only one I had was huge ) checked everything with bleep on meter and also found a loose connection put it all back together and its charging so thanks everyone
whitch wires did you clean and whitch 1 was loose i have the same problem on my 3.2
whitch wires did you clean and whitch 1 was loose i have the same problem on my 3.2
11
Omega General Help / Re: cluch bleeeder nipple
« on: 24 September 2009, 23:02:54 »
OK THANKS IL TRY THAT 
13
Omega General Help / Re: cluch bleeeder nipple
« on: 24 September 2009, 20:43:13 »
what would the proper name for it b??
14
Omega General Help / Re: cluch bleeeder nipple
« on: 24 September 2009, 20:38:28 »
problemm is ive totaled the nipple housing to and need a replacement and dont no wer to get 1
15
Omega General Help / cluch bleeeder nipple
« on: 23 September 2009, 15:53:02 »
hi does any1 no wer i could get a clutch bleeder nipple as ive snaped mine in half inside the housing
Pages: [1] 2