1
Omega Electrical and Audio Help / Re: fuse 15 on 52 reg CDX
« on: 05 December 2009, 11:48:58 »
Fuse 15 blowing problem fixed.
First of all, thanks to all of you that responded to my request for info, it was all very helpfull.
Also, the AA guy was extremely helpfull.
I searched everywhere for a circuit diagram and eventually downloaded one from . It took a while to work out how it worked but ended up being an extremely powerful piece of kit. It is all in the instructions.
It turned out, after a lot of searching and a lot of luck to be something to do with under the drivers seat. Incidentally, it blew when going round a left hand corner or leaning to the right on the seat. I bought a 10A circuit trip from Maplin for under £2.00 and it was extremely helpful.
I've still got it disconnected so I don't know if it's the seat heater or seat adjust system.
Thanks again guys and hopefully this will help someone else in the future.
Regards,
Tony
First of all, thanks to all of you that responded to my request for info, it was all very helpfull.
Also, the AA guy was extremely helpfull.
I searched everywhere for a circuit diagram and eventually downloaded one from . It took a while to work out how it worked but ended up being an extremely powerful piece of kit. It is all in the instructions.
It turned out, after a lot of searching and a lot of luck to be something to do with under the drivers seat. Incidentally, it blew when going round a left hand corner or leaning to the right on the seat. I bought a 10A circuit trip from Maplin for under £2.00 and it was extremely helpful.
I've still got it disconnected so I don't know if it's the seat heater or seat adjust system.
Thanks again guys and hopefully this will help someone else in the future.
Regards,
Tony