1
Newbie Welcome Area / Re: Newbie saying hello.
« on: 24 May 2012, 19:39:01 »
hello and welcome
- 14 May 2025, 15:00:19
- Welcome, Guest
News:
Please check the Forum Guidelines at the top of the Newbie section
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1] 2
2
Newbie Welcome Area / Re: Just transfered from VVOC.COM
« on: 24 May 2012, 08:34:26 »
greetings and hello
6
Omega General Help / Re: Key transponder
« on: 07 November 2011, 06:29:17 »
many thanks to you all
7
Omega General Help / Re: Key transponder
« on: 06 November 2011, 17:07:34 »
Many thanks yes i have the car pass will look on ebay
8
Omega General Help / Key transponder
« on: 06 November 2011, 16:50:53 »
Hi is it possible to get hold of the transponder as my sister has lost the transponder to my spare set key works ok just transponder missing i have a old set of key to a scrapped omega would i be able to recode that one.
9
Omega Electrical and Audio Help / Re: headlight upgrade
« on: 26 June 2011, 22:49:33 »
go this is a mine field will have to give it a thought or just get hold off som projector light s
10
Omega Electrical and Audio Help / Re: headlight upgrade
« on: 26 June 2011, 19:21:32 »
thanks all got my eye on a pair
11
Omega Electrical and Audio Help / Re: headlight upgrade
« on: 26 June 2011, 10:25:10 »
my headlamp washers work ok is it not just a simply swap over.
12
Omega Electrical and Audio Help / Re: headlight upgrade
« on: 25 June 2011, 19:21:25 »
NO mines a 97 p reg so lucked out. my have to get them. thanks
13
Omega Electrical and Audio Help / headlight upgrade
« on: 25 June 2011, 19:15:50 »
hi all my first post so sorry if its been asked befor. I did look. Can i up grade to xenon lights from standard ?. if so what is needed just complate light and ballist pack then plug and play
regards
regards
14
Omega General Help / Re: Elite screen glass spec
« on: 07 August 2011, 15:42:16 »
The rubber blocks are not seen and just stop screen sinking after laying in. The trims have allways been tight to get on and risk shelling the glass
15
Omega General Help / Re: Elite screen glass spec
« on: 06 August 2011, 18:36:42 »
The rubber blocks are tiny but give enough support to stop the glass sinking tight to the body when you have layed it in. not all fitters use them. the slighest mark on the edge can cause a stress crack
Pages: [1] 2