Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Search the maintenance guides for answers to 99.999% of Omega questions

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Johna

Pages: [1] 2 3 4
1
Omega General Help / Re: Very quick rocker cover gasket question
« on: 08 November 2011, 10:38:25 »
At great personal risk to my health (from the missus  :D) I have delayed starting the job to hunt down some genuine Vauxhall parts, following everyones advice to stay away from the pattern parts, and I have found one set in the whole of the North East. They reckon they "might" be able to have another set by the end of the week. Is it possible to do one side at a time? I believe it is only the passenger side blown.

They have the O-rings in sealant in stock  ;D

2
Omega General Help / Re: Very quick rocker cover gasket question
« on: 07 November 2011, 23:18:33 »
I know it should be but the only place that has any in stock for tomorrow is europart and I'm desperate for the car - any idea which one? I know ill prob end up doing it again in a couple months

Cheers

John

3
Newbie Welcome Area / Re: hi all
« on: 07 November 2011, 19:41:52 »
Hi Tom & welcome

4
Omega General Help / Very quick rocker cover gasket question
« on: 07 November 2011, 19:39:48 »
Hi All

Looks like I need to do my rocker cover gasket and need a quick bit of advice. I know I should be using the Vauxhall part but I need to get it done tomorrow and the only place with the part in stock is Eurocarparts. They said they have them in stock but there are two choices, one where it looks like it is a single side, and one where there appears to be two sides joined together like a butterfly.

I have a 2001 2.6 CD. Which gasket should I go for? I want to start by just doing the passenger side first if thats possible?

Thanks

John


5
Omega General Help / Re: Lots & lots of fault codes!!!
« on: 05 November 2011, 12:44:04 »
Hi All!!

Just to let you all know, I have a working mig again!!  ;D ;D ;D

Just want to give a huge THANK YOU to everyone who helped, especially to RobG & Twiglet  :y :y top guys who supplied the necessary parts.

I removed the coil pack this morning on 2-4-6 and discovered spark plug wells were brimmed with oil & water. It looks like its been like that for some time as the the rubbers were shot - part had even dropped off the rear rubber in to the back well and took a while to get out. Having cleaned them all out and checked the plugs, it all went back together with the new coil pack and bingo!! Working mig!

Can I also say that Markjay's how to on plug removal was spot on too!

There is one small problem that's developed  :-\ I have to crank it for a while before it starts. I'm wondering if I've disturbed a fuel pipe or something as it sounds like its turning over dry? I'm wondering if its because I took a couple of the plenum bolts out to screw into the coil pack for removal. Could this have done it?

Many thanks to everyone again!   :y


6
Omega General Help / Re: Lots & lots of fault codes!!!
« on: 28 October 2011, 13:21:17 »
My wife reckons it feels the same as when the crank sensor went in our last mig. Is it possible for this to die (or start to fail) and not register?

7
Omega General Help / Re: Lots & lots of fault codes!!!
« on: 28 October 2011, 13:13:53 »
Hi again

I have fitted a new maf sensor (many thanks RobG!!) but unfortunately it hasn't cured my symptoms. Think I'm going to have to book the car in to a diagnostics place.

I have driven it 35 miles to work this morning as replacing the maf did seem to improve it, but it's still definitely not on all 6 cylinders. Above 70mph doesnt seem too bad at all. Around 40 its a pig though. At slow speeds on a light throttle doesn't seem too bad either. I have re-checked my codes after the drive to work and there's nothing new there.

8
Omega General Help / Re: Lots & lots of fault codes!!!
« on: 24 October 2011, 18:49:15 »
Thanks for the replies!

I've just checked rechecked the codes and there are no new ones in there (the MAF is still disconnected).

Would the engine run lumpy if the car had been running normally and I had disconnected the MAF?

And how do I get the live data - do I need a to get a dealer to plug it in for this?

Thanks

John

9
Omega General Help / Re: Lots & lots of fault codes!!! MAF?
« on: 24 October 2011, 15:27:18 »
Okay, so tried driving the car for a decent run out. With the maf connected the car wouldn't start.

Disconnected MAF, car started straight up!

Out on the drive with the MAF disconnected, the car did drive better but like it's mssing on some cylinders (which the error codes pointed to originally). Would have the MAF disconnected make it feel like this?

Now I'm wondering if i have more problems than just a knackered MAF? The car has run perfectly before this problem just appeared last week.


10
Omega General Help / Re: Lots & lots of fault codes!!!
« on: 24 October 2011, 14:47:56 »
I tried driving the car with the MAF disconnected, and I think it drove better, certainly no worse  :-\

Does anyone know if that points to the MAF or not?

Cheers

John

11
Omega General Help / Re: Lots & lots of fault codes!!!
« on: 24 October 2011, 13:41:34 »
Been doing some more research on MAF problems, should I try disconnecting the MAF and see if it makes any difference? If it's the MAF will it run the same or should it improve?

Many thanks

John

12
Omega General Help / Re: Lots & lots of fault codes!!!
« on: 24 October 2011, 11:53:31 »
Forgot to mention its a 2001 2.6CD

Thanks

John

13
Omega General Help / Lots & lots of fault codes!!!
« on: 24 October 2011, 11:52:23 »
Hi All

I reported problems on my car last week with loss of power and was kindly pointed towards maf sensor. I tried cleaning it out with some proper cleaner in the hope that might help, and I think it may have, briefly, but the problems came back. I'm just about to order a new maf but thought I would check the codes again - originally I had a 0173 and 0170.

I just checked and have these codes now too:

P0704 Clutch Switch Input Circuit Malfunction
P0130 (There's 4 choices for this one!)
P0325 (There's 2 choices for this one - I thought I had counted 0324 but can't see a result for that?)
P0330
P1523 Electronic Throttle Control Malfunction (again i thought it was 1513 - maybe I mis-counted?)
P0300 Random/multiple cylinder misfire detected
P0306 Cylinder 6 Misfire Detected
P0300 Random/multiple cylinder misfire detected (another one)

Before I take out a second mortgage for a new maf, does this still sound like maf symptoms?  :-\

Many thanks

John

14
Omega General Help / Re: loss of power
« on: 14 October 2011, 14:52:04 »
Many thanks - excuse my ignorance here, but whats the ram and what would i look for to see if its broken or blocked?

Cheers

John

15
Omega General Help / Re: loss of power
« on: 14 October 2011, 14:28:21 »
Oops! Thought it was in my info - it's the 2.6 reg 2001

Thanks

John

Pages: [1] 2 3 4

Page created in 0.008 seconds with 13 queries.