Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Search the maintenance guides for answers to 99.999% of Omega questions

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - aix from estonia

Pages: [1] 2
2
i think that then this problem started. i dont know exactly. when i take the plug out then the engine works even worse. it was sale with diesel pump failure. but i think that the diesel pump is fine. anyway it would be good to diagnose the car, but i cant.

4
still need ecu wiring  :(

5
ok but when i remove ecu then there should be no resistanse. iŽl tri this tomorrow. there was resistance about 110 ohms.

6
ok we mesured in diagnostic connector (i dont remember exactly) one pin was 12v other - the rest of pins were no resistance accsept pin nr 7 there ws resistance with - .hope you understand

7
ok. but in diagnostic connector there is only one wire for ecu,radio and speedometer. why i need more? yes w tried to search them. one tester wire to pin 7 and we tried all pins in ecu connector put no luck.

8
i donŽt find anything also.  :-/

9
witch pin in ecu is diagnostic pin? maybe if i cut of the old wire and replace it with new. on end to the ecu and an other to diagnostic connector. then ill get acsess to ecu.

10
if you mean crankshaft position sensor, then the last owner changed it. i think then this problem started.

Sorry I meant when the pattern cam sensor was used.

sorry i dont understand what do you mean  whit this (my english is so bad  :-[)

11
pin 7 was ok. we removed radio and speedometer. still no response from ECM. somethin is blocking signal. i think i need a wiring chart that i can get singnal straight from ECM.

12
let`s hope so. ill try again tommorow. lets home tahat 7th pin is just broken.

13
it didnt find speedo also. i think we dint tried to access radio. abs, airbags and central locking were ok. it means that equipment found them. maybe theres a fault in daignostic connector.

14
does anyone have some wiring chart. or some info. where to get some?

Pages: [1] 2

Page created in 0.008 seconds with 13 queries.