Topic: Are there any E9 torx screws on Omegas? (Read 1179 times)

terry paget · « **on:** 24 July 2016, 21:15:58 »

I am stripping KR02 a petrol 2.2 for spares. Trying to harvets the crank sensor, I cannot get either an E8 or E10 socket to fit on the screw head. It could not be an E9 could it? Cam sensor is an E8.

terry paget · « **Reply #1 on:** 24 July 2016, 21:52:38 »

I have just checked the maintenance guide. It's written by me, says the screw is an E10 head, but can be undone with an 8mm socket. I shall try again tomorrow.

flyer 0712 · « **Reply #2 on:** 24 July 2016, 22:54:13 »

Think if you use a 12 point 8mm socket it should do the job..

TheBoy · « **Reply #3 on:** 25 July 2016, 11:14:11 »

And no E9's used on the car

terry paget · « **Reply #4 on:** 25 July 2016, 16:47:35 »

Thank you gentlemen. Found a 12 sided 8mm socket, fitted straight away. Removed screw, waggled sensor out, pulled cable through no trouble, now I have a spare.
As said in my guide, removal is easy; replacement is trickier. Hard bit is getting the screw back in. I have had to remove the engine mounting to do it, but it should go in same way a the old came out.i

News:

Author Topic: Are there any E9 torx screws on Omegas? (Read 1179 times)

terry paget

Are there any E9 torx screws on Omegas?

terry paget

Re: Are there any E9 torx screws on Omegas?

flyer 0712

Re: Are there any E9 torx screws on Omegas?

TheBoy

Re: Are there any E9 torx screws on Omegas?

terry paget

Re: Are there any E9 torx screws on Omegas?