Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[Patriciajosephine]

Hi all
I have a 2.6 v6 2003 B series and my hubby having problems removing starter motor and unable to remove drivers side engine mount... any advice welcomed... thanks

[Doctor Gollum]

Unlucky to have had the starter fail

Short 16mm offset ring spanner to undo the mount plus jack and block of wood to lift the engine

[Patriciajosephine]

Thanks for that... hubby says does he have to remove the w
Expansion bottle to access the top bolt on mount....
Yes i say unlucky as this is the 2nd starter motor in 2 years but hubby determined to fit himself to save garage fees as last time

[Doctor Gollum]

Moving the bottle won't hurt, but not necessary. Don't drain it, just pop the clip, slide the bottle out and plonk to one side

If undoing that side doesn't give enough space, undo the other side as well and prop the sump on a block against the subframe.

[Patriciajosephine]

Thanks so much 

[johnnydog]

I've done two relatively recently due to faulty solenoids - in both cases, I found it far easier to gain access to the starter motor mounting bolts ( to then to remove it from the engine) by undoing the three bolts for the alloy engine mounting bracket and removing it with the engine supported under the sump on a trolley jack.