Topic: omega 2.5 diesel inlet manifold torque settings?? (Read 848 times)

sess · « **on:** 31 December 2008, 20:17:35 »

hi all,

i need to take the inlet manifold off my 2000 2.5 td to replace the gaskets.......
does anyone know if there is any specific way of tightening i.e in a particular order and what the correct torque settings are?

many thanks and happy new year to you all

TheBoy · « **Reply #1 on:** 31 December 2008, 21:28:33 »

no particular order. Don't have roque settings to hand, sorry

Seth · « **Reply #2 on:** 01 January 2009, 10:48:43 »

Initially, just tighten all the nuts evenly, so that the manifold is sitting securely to the cylinder head.

Then torque each nut to 23 Nm. This is Vx's official figure.

Good practise means that you'd start by torquing Nos 3 and 4 inlets first, then 2 & 5, and finish on 1 & 6, though I've not heard of any problems whichever way they're tightened-up.

While the manifold's off, stuff a rag in the inlet ports on the cylinder head to ensure that no foreign matter enters the combustion chambers. Good luck fella ..... !

sess · « **Reply #3 on:** 01 January 2009, 18:38:53 »

cheers matey just the info i was looking for top man

News:

Author Topic: omega 2.5 diesel inlet manifold torque settings?? (Read 848 times)

sess

omega 2.5 diesel inlet manifold torque settings??

TheBoy

Re: omega 2.5 diesel inlet manifold torque settings??

Seth

Re: omega 2.5 diesel inlet manifold torque settings??

sess

Re: omega 2.5 diesel inlet manifold torque settings??