Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: [1]   Go Down

Author Topic: Run out of ideas on EML  (Read 986 times)

0 Members and 1 Guest are viewing this topic.

Bob G

  • Intermediate Member
  • ***
  • Offline Offline
  • Gender: Male
  • Gloucester
  • Posts: 452
    • View Profile
Run out of ideas on EML
« on: 27 November 2013, 21:42:24 »

The issues is EML is on but the circumstances are (to me) strange:
it only comes on once engine is warm, car run fine and can reach 70mph no issues then it does start to bang a bit
 have replaced cam shaft sensor with known good one and light stayed on
codes read 335 and 340

it all seemed to start after trying to free top heater matrix hose, BUT if I had disturbed something then would not the light be on straight away.

X reg 2.0L dual fuel
Logged

blackviper90210

  • Omega Baron
  • *****
  • Offline Offline
  • Gender: Male
  • Bromsgrove, West Midlands
  • Posts: 2486
    • 03 3.2 Elite Saloon
    • View Profile
Re: Run out of ideas on EML
« Reply #1 on: 27 November 2013, 23:22:39 »

Duel fuel? If your running LPG, that might upset a sensor somewhere maybe? ???
Logged
AKA - Mr Bracket

Bob G

  • Intermediate Member
  • ***
  • Offline Offline
  • Gender: Male
  • Gloucester
  • Posts: 452
    • View Profile
Re: Run out of ideas on EML
« Reply #2 on: 27 November 2013, 23:46:27 »

poss but only running petrol at the moment
Logged

Bob G

  • Intermediate Member
  • ***
  • Offline Offline
  • Gender: Male
  • Gloucester
  • Posts: 452
    • View Profile
Re: Run out of ideas on EML
« Reply #3 on: 28 November 2013, 09:37:06 »

also problem only occurs with hot engine
Logged

Bob G

  • Intermediate Member
  • ***
  • Offline Offline
  • Gender: Male
  • Gloucester
  • Posts: 452
    • View Profile
Re: Run out of ideas on EML
« Reply #4 on: 28 November 2013, 09:51:48 »

any ideas where I can get a genuine cam sensor (old style) to eliminate it as the cause, not to sure about the "genuine" Siemens on auction site, and my VX dealer only does the new style with a build it yourself 6 core loom to splice in.
Logged
Pages: [1]   Go Up
 

Page created in 0.009 seconds with 17 queries.