Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[sophos9]

Sorry mate, I understand what you are saying now. So as one side is not holding pressure, the entire system should not hold any.

If this is the case, how come the side that has a seal is pressurised (unless of course there are check valves inline?)

Thanks

[sophos9]

Bought some o rings today, jacked up each side, removed the old, fitted the new then dropped car back down.

Once done, started car - heard compressor, drove car on level ground and measured the distance from the floor to the arch.

F N/S - 26.5inch
F O/S - 27inch
R N/S - 27inch
R O/S - 27.5inch

Previous, the rear near side was about 1.5inches higher than the rear off side. Will measure the distance again tomorrow. If there is a leak, I would expect to see a difference...