Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please play nicely.  No one wants to listen/read a keyboard warriors rants....

Pages: 1 [2]  All   Go Down

Author Topic: 3 Stage Cooling Fan - When should it cut on?  (Read 2584 times)

0 Members and 1 Guest are viewing this topic.

Greg2041

  • Junior Member
  • **
  • Offline Offline
  • Gender: Male
  • Frinton-on-Sea
  • Posts: 96
    • View Profile
Re: 3 Stage Cooling Fan - When should it cut on?
« Reply #15 on: 07 August 2009, 09:02:03 »
Help.  Please reply asap as I have an electrician doing some checks for me.

Pins 4 & 5 work but we can't find the Primary and Secondary Therm Connector which we assume goes to the stat.  Anyone know where they are?

Thank you
« Last Edit: 07 August 2009, 09:12:06 by Greg2041 »
Logged

Greg2041

  • Junior Member
  • **
  • Offline Offline
  • Gender: Male
  • Frinton-on-Sea
  • Posts: 96
    • View Profile
Re: 3 Stage Cooling Fan - When should it cut on?
« Reply #16 on: 07 August 2009, 10:04:14 »
It appears as if the PDF relates to post-1998 models as the wiring colours are slightly different and there appears to be only one radiator switch.

The good news and it's all thanks to this forum and you guys is that all the electrical checks have been done so it appears that the fault lies with radiator switch.

Thank you so much.

Greg
Logged

Richard A

  • Senior Member
  • ****
  • Offline Offline
  • Gender: Male
  • Aldridge, West Midlands
  • Posts: 865
    • View Profile
Re: 3 Stage Cooling Fan - When should it cut on?
« Reply #17 on: 07 August 2009, 18:11:41 »
Please look at the righthand side of the diagram ie "Primary Therostatic Switch" then below
"Secondary Thermostatic Switch",
if your car has 'aircon' this arrangement is the same since 1994 until 2004.
Regards
richard a
Logged
richard a

Greg2041

  • Junior Member
  • **
  • Offline Offline
  • Gender: Male
  • Frinton-on-Sea
  • Posts: 96
    • View Profile
Re: 3 Stage Cooling Fan - When should it cut on?
« Reply #18 on: 04 September 2009, 22:45:03 »
Thermostatic Fan Switch

I finally have the part.  Do I need to disconnect anything to fit it?  Is it a case of just unbolting the existing one and refitting the new one?

Thanks again..............
Logged
Pages: 1 [2]  All   Go Up
« previous next »
 

Page created in 0.012 seconds with 17 queries.