Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: [1]   Go Down

Author Topic: TD ar35 torque settings  (Read 589 times)

0 Members and 1 Guest are viewing this topic.

BRIGSPORT

  • Newbie
  • *
  • Offline Offline
  • Sunny Lancashire
  • Posts: 28
    • View Profile
TD ar35 torque settings
« on: 02 September 2010, 18:12:22 »
What are the torque settings to use when changing bell housings, and also tightening sequence? Thanks.
Logged

Kneepad

  • Omega Knight
  • *****
  • Offline Offline
  • Gender: Male
  • West Scotland
  • Posts: 1409
    • View Profile
Re: TD ar35 torque settings
« Reply #1 on: 02 September 2010, 19:00:44 »
Torque
3 upper screws for converter housing to engine – 60 Nm / 44 lbf. ft. 2 screws  for starter to engine – 40 Nm / 29.5 lbf. ft.
Cover plate to converter housing (1 screw) – 5 Nm / 3.7 lbf. ft.
Converter to drive plate (3 screws) – 55 Nm / 40.5 lbf. ft. Insert cover cap.
 
4 lower fastening bolts  to converter housing (M8) – 20 Nm / 15 lbf. ft.
4 lower fastening bolts  to converter housing (M10) – 40 Nm / 29.5 lbf. ft.
1 lower fastening bolt  to converter housing – 60 Nm / 44 lbf. ft.

No tightening sequence given but if you go to diagonally opposing bolt you won't go wrong.   :y
Logged

BRIGSPORT

  • Newbie
  • *
  • Offline Offline
  • Sunny Lancashire
  • Posts: 28
    • View Profile
Re: TD ar35 torque settings
« Reply #2 on: 02 September 2010, 20:13:59 »
Thank you very much. :y
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.013 seconds with 17 queries.