Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Search the maintenance guides for answers to 99.999% of Omega questions

Pages: [1]   Go Down

Author Topic: bonnet release  (Read 727 times)

0 Members and 1 Guest are viewing this topic.

fiend61

  • Omega Knight
  • *****
  • Offline Offline
  • Gender: Male
  • york
  • Posts: 1544
  • each to their own
    • 2.5cdx 3.0mv6 3.2vec c
    • View Profile
bonnet release
« on: 15 May 2011, 21:06:16 »
hi all
got a problem with the lever that pops the bonnet, it is hanging off like someone has pulled too hard  :-[
i havent taken it apart yet but some advice would be good  :)
would it have snapped needing new handle?
or would fixings have broken that handle attatches to?
advice would be good so can get bits beforehand
tia  :y
Logged

Cotty

  • Newbie
  • *
  • Offline Offline
  • Gender: Male
  • Darwen,Lancashire
  • Posts: 28
    • View Profile
Re: bonnet release
« Reply #1 on: 15 May 2011, 23:06:53 »
The same thing happened to me on my old 2.0l  ::) .
Luckily on mine the cable had popped out of its mechanism inside the lever and armed with a torch and a pair of pliers I soon had it back in working order ;).
Also make sure that the cable has'nt come loose anywhere under the bonnet as this will make it bloody hard to open,the first place to check would probably be where the cable is clipped to the plastic trim just above the back of the plenum.
Hope yours is an easy fix like mine :y
Logged

fiend61

  • Omega Knight
  • *****
  • Offline Offline
  • Gender: Male
  • york
  • Posts: 1544
  • each to their own
    • 2.5cdx 3.0mv6 3.2vec c
    • View Profile
Re: bonnet release
« Reply #2 on: 16 May 2011, 06:56:02 »
Quote
Luckily on mine the cable had popped out of its mechanism inside the lever
no the cable hasnt come off it is still attatched to handle but the handle is hanging loose, you can still pull on the handle top and bottom to release bonnet, so either handle has snapped or where the handle fits onto has snapped, i will probally strip it down next weekend to have a look, i just wondered if this had happened to anyone else so i could have got bits before i started to strip it down ?
Logged

Abiton

  • Guest
Re: bonnet release
« Reply #3 on: 16 May 2011, 07:54:52 »
Quote
Quote
Luckily on mine the cable had popped out of its mechanism inside the lever
no the cable hasnt come off it is still attatched to handle but the handle is hanging loose, you can still pull on the handle top and bottom to release bonnet, so either handle has snapped or where the handle fits onto has snapped, i will probally strip it down next weekend to have a look, i just wondered if this had happened to anyone else so i could have got bits before i started to strip it down ?

Yep, more than a couple of times...

There's a (fixed, round) bit of plastic on the bit that falls out which is a sort of hinge pin IIRC, which just 'clips' into the fitting that's attached to the car.  It's a horribly  cheap-looking set-up for such an elegant car.

The good news is that it will probably just pop back in, once you get a torch and your head down there so you can see what you're doing.

Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.013 seconds with 17 queries.