Topic: No Starter opertion via Ignition key (Read 2630 times)

TP · « **Reply #15 on:** 31 October 2011, 06:46:05 »

Well some embarrassing red faced feed back feedback

. I got nowhere with the oil sensor (No cleaned) or the ignition switch all working ok so it had to be a wiring fault.
So I studied the Haynes wiring diagram with my magnify glass

and noticed that both the oil sensor wiring and the line to/from the AT switch shared the same connecter "X2".
So I traced the line from the starter solenoid back thru the engine front wiring trunking and opps

the locking ring on one of the round multiplugs just below and NW of the battery had unlocked

and the connection had been loose over the last few months and then had finally parted

.
The only good side for me was I did an oil change in both the AT and the Engine.

Many thanks for all your suggestions anyway

Kevin Wood · « **Reply #16 on:** 31 October 2011, 09:08:44 »

Glad it's sorted.

News:

Author Topic: No Starter opertion via Ignition key (Read 2630 times)

TP

Re: No Starter opertion via Ignition key

Kevin Wood

Re: No Starter opertion via Ignition key