Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: [1]   Go Down

Author Topic: yes another camshaft related question  (Read 1240 times)

0 Members and 1 Guest are viewing this topic.

Essex_Andy

  • Senior Member
  • ****
  • Offline Offline
  • Gender: Male
  • Have a guess?
  • Posts: 501
    • View Profile
yes another camshaft related question
« on: 02 February 2007, 20:49:32 »
Just going through my tools and sockets and I dont have anything that will surfice as a drift for the camshaft oil seals....

Any suggestions fellas?
« Last Edit: 02 February 2007, 20:54:59 by Essex_Andy »
Logged
If an artic overtakes you, you're driving too slow!!!!!!!!!!!

JamesV6CDX

  • Omega Queen
  • *****
  • Offline Offline
  • Gloucestershire/Buckinghamshire
  • Posts: 16640
    • Omega 3.2 Retail MV6 LPG
    • View Profile
Re: yes another camshaft related question
« Reply #1 on: 02 February 2007, 21:10:01 »
Get a socket, at a guess over 30mm....
Logged

Essex_Andy

  • Senior Member
  • ****
  • Offline Offline
  • Gender: Male
  • Have a guess?
  • Posts: 501
    • View Profile
Re: yes another camshaft related question
« Reply #2 on: 02 February 2007, 21:42:28 »
largest I have is 1 1/4 inch and thats too small....mind you I have since found some thick wall pipe that will do but I can draw a straight line but bloody cant saw one!!!!
« Last Edit: 02 February 2007, 21:43:26 by Essex_Andy »
Logged
If an artic overtakes you, you're driving too slow!!!!!!!!!!!

Marks DTM Calib

  • Administrator
  • *****
  • Offline Offline
  • Gender: Male
  • West Bridgford
  • Posts: 34012
  • Git!
    • View Profile
Re: yes another camshaft related question
« Reply #3 on: 04 February 2007, 09:20:01 »
You dont need one......you can easily fit the seal to the cams (lube it with oil) and then drop the asembly in....fit the bearing cap and jobs a good un...
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.011 seconds with 16 queries.