Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Search the maintenance guides for answers to 99.999% of Omega questions

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - dong

Pages: [1]
1
Omega General Help / Re: poor running and missfire
« on: 12 November 2007, 19:08:16 »
thanks guys for the info sorted it now it was the dis unit put a new one on and its running fine now  :)
put some new leads on aswell, should have done them when i rebuilt the engine but it was getting expensive and they looked fine  :P   thanks again

2
Omega General Help / poor running and missfire
« on: 12 November 2007, 10:06:12 »
hi guys can anyone give me advise
i have just rebuilt my 2.5 v6 engine and refitted it, its was running sweet for the fisrt couple of days then 2 nights ago it started miss fireing while i was driving it seemed to even out as revs picked up but still there
tried it again this morning and it took a while to get it started, it seems very lumpy and still missfiring
i have tried the paper clip test even though the management light was not on and it gave these codes

19  rpm signal incorrect
135 check engine lamp low voltage

do you think replacing the crank sensor would cure this or could it be another fault any advise is most welcome


omega 2.5v6 1997 reflection

3
Newbie Welcome Area / Re: hi there
« on: 05 July 2007, 15:02:21 »
cheers guys nice to be made welcome  :)

4
Newbie Welcome Area / hi there
« on: 04 July 2007, 21:14:28 »
hello everyone my name is lee

after driving a few and servicing 1 or 2 ive finaly got myself an omega 2.5 v6 1997 in silver.
i got this car cheep off a friend, its in very good condition apart from the fact that he blew the engine on it
im un sure what to do with the engine though
do i rebuild and maby do a few mods to the engine  :-/  or go the whole hog and stick a 3 litre in it

i am undesided as i havent done much work on omegas and i dont know what else would need to be changed if i put the 3 litre in it   ( ie ecu, wireing loom etc ) any advice would be most welcome   :)

Pages: [1]

Page created in 0.008 seconds with 14 queries.