Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Omega Electrical and Audio Help / Re: Bluetooth

« on: 02 August 2010, 23:13:15 »

Do you have the stubby aeriel on the rear of your car assuming it's a saloon?
If so remove the glove box and there should be a plug with all the phone connections stuck up which you can get an adapter to plug straight into the bluetooth kit.

Where do I get this adapter from & what is it called please?

2

Omega Electrical and Audio Help / Bluetooth

« on: 02 August 2010, 21:44:47 »

Hi, I have an S reg 2.5 Elite with the CDR 500 radio, I am installing a Nokia CK-20W, what wire from the back of the stereo is the mute for when the phone rings please?

3

Omega General Help / Re: Paper Clip Test

« on: 03 March 2010, 10:31:10 »

Nope, won't start... So looks like I need a new Mass air flow sensor.. ?

4

Omega General Help / Re: Paper Clip Test

« on: 03 March 2010, 10:02:50 »

Not tried it this morning yet, the fuel light never usually flashes it stays solid, unless the gauge is wrong, but then why the EM light coming on just before it stopoped?.. boo hoo... I will go try it..

5

Omega General Help / Re: Paper Clip Test

« on: 03 March 2010, 09:41:31 »

When EM light came on there was 30 miles, but then fuel light was flashing, this is new, I got to a station & now there is 80 miles ish, it never really started after I put the fuel in.

6

Omega General Help / Re: Paper Clip Test

« on: 03 March 2010, 09:30:40 »

OK, Mr Star..lol.. it is giving me :-

73   Mass Air Flow Sensor Voltage Low
74   Mass Air Flow Sensor Voltage High
 Would this make the car do what it is doing, I am sure it would, can I just go buy a mass air flow sensor & where is it located please?? Cheers..  Col

7

Omega General Help / Re: Paper Clip Test

« on: 03 March 2010, 08:51:47 »

Many thanks, you are a star !!!!!!!!!!!!

8

Omega General Help / Paper Clip Test

« on: 03 March 2010, 08:42:21 »

Hey all, can someone tell me what terminals I use for the paper clip test, X25XE S plate. EM light came on, car cut out, the fuel light started to flash, now none starter for more than a minute. What does the flashing fuel light mean, it is usually solid for low fuel... Please tell me it is just the fuel pump... :-/

9

Omega General Help / Water pump

« on: 30 December 2009, 13:00:57 »

Hi, can anyone tell me if the cam belt is compromised if the water pump dies please? & is there a simple way to change the pump or am I following Haynes to the letter? X25XE V6 cheers..

10

Omega General Help / Intake Manifold Valve 1

« on: 18 September 2008, 18:43:20 »

Can any one tell me where this valve is & a cure for low voltage, I believe this is causing my misfire. I just spent £500 replacing electrics & it still misfires. Paperclip tells me low voltage to Intake Manifold Valve 1 . My car hates me!!! HELP PLEASE!!!

11

Omega General Help / Re: Misfire

« on: 14 September 2008, 21:22:20 »

OK, where is the EGR valve located please & what is a Plenum & where is that located also please, & is the plenum part of the EGR valve or the other valve.? Sorry, I will learn soon & one day might be able to help others, or do you think there is no hope for me...lol, Cheers

Take the EGR valve off and clean it well ith paint sripper until the pintel inside moves freely, re-sit and then block the two ports off with a bit of coke can as I suspect it might be stuck open!

Check also the connection to the rear of the plenum which operates the multiram.

12

Omega General Help / Re: Misfire

« on: 14 September 2008, 20:17:01 »

WOW that is awesome, ty so much, ok, my next thing is,  where is the manifold valve & do I just replace it & same with the EGR valve? any suggestions, I am sure all connections are good around the engine. Many thanks, you guys are Genius's you eally are...

132   Exhaust Gas Recirculation (EGR) Valve Feedback Incorrect Signal
59   Intake Manifold Valve 1 Voltage Low
31   No Engine RPM Signal - normal with the engine not running

all here ... http://www.omegaowners.com/forum/YaBB.pl?num=1160152415

I'd be checking the connections around the engine to ensure evrything is plugged in properly ...

13

Omega General Help / Re: Misfire

« on: 14 September 2008, 19:16:26 »

OK, I have done the "paperclip" test & these seem to be the codes I have, can anyone tell me what they mean please.........132-,59,-&31 Many Thanks.

Watch the video!! - http://images.omegaowners.com/images/guides/paperclip_test/paperclip.html

14

Omega General Help / Re: Misfire

« on: 14 September 2008, 13:12:10 »

Hi, I did the paperclip test & to be honest I just do not understand what I am looking at, the EML does flash but then flashes in different sequences. Any chance of someone calling me & talking me through it, I know I am a pain in the butt, & am sorry? So can you call? Please.

I just replaced everything at once as it is a pain to get to things,I just thought it easier & thought that would do the trick once & forall

Air leak?? Did you just replace stuff randomly to see if it fixed it?? If you have an EML light on then paperclip it

Ok, what is a paperclip test please?

15

Omega General Help / Re: Misfire

« on: 14 September 2008, 12:09:47 »

Hi, I did the paperclip test & to be honest I just do not understand what I am looking at, the EML does flash but then flashes in different sequences. Any chance of someone calling me & talking me through it, I know I am a pain in the butt, & am sorry? So can you call? Please.