Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Omega General Help / Re: Torque Settings

« on: 24 October 2008, 23:21:43 »

Thanks for the help

2

Omega General Help / Torque Settings

« on: 24 October 2008, 23:07:14 »

Hi can anyone tell me wot the torque should be for the inlet to manifold on the V6. Iv just changed the rocker cover gaskets and will be putting it back together 2moro. Also the plenum torque too, im ok with the rockers at 8nm just the others ta. :-? :-/

3

Omega General Help / Re: Torque settings for rocker covers

« on: 18 October 2008, 17:50:15 »

Ok looks like a trip to halfords 2moro then. Thanks 8-) 8-)

4

Omega General Help / Torque settings for rocker covers

« on: 18 October 2008, 17:39:17 »

HELLLLLPPPPP. Iv just found out my torque wrench dont go down to 8nm Is this the right torque for rocker covers??? If so is there anyway of guesstimating  this torque???

5

Omega General Help / Re: rocker cover replacement????????

« on: 11 October 2008, 13:15:43 »

Thanks for all advice.
Now to find a garage who wont rip me off to do the job. Any one near kings lynn who wants to do it for me?? :-/

6

Omega General Help / rocker cover replacement????????

« on: 10 October 2008, 20:30:57 »

Iv just got my 2.5 omega back from the garage and was told that I need to replace both rocker covers b4 they can change the plugs as oil is going into the plug holes. Do these rockers not have gaskets that can be replaced if not can anyone tell me where i can get a pair of rockers from cheaper than the main dealer price of £87+ the dreaded?

thanks