Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - deejag94

Pages: [1]

Omega General Help / Headlight Switch back light change/replace

« on: 14 October 2010, 00:05:09 »

Omega 2.2 CD ecotec 2002 model
Can anyone help in telling me how to replace the back light bulb in headlight on/off switch please. Thanks

Omega General Help / Re: Auto grearbox in Limp / Safe mode on start up

« on: 05 May 2010, 09:49:13 »

Thanks for all your advice guys, will do what you suggest and replace the Camshaft sensor with genuine part ... following Vic's great "how to" tutorial on here.
I'm new to this site (only just found it) its really great and you are all very helpful....THANKS
Will let you know how it goes after the weekend

Omega General Help / Auto grearbox in Limp / Safe mode on start up

« on: 04 May 2010, 13:36:05 »

Omega 52 plate 2.2 ecotec petrol CDX
Please can anyone assist..
Sometimes on start up gearbox goes into "limp / safe mode. This only occurs on start up and then only happens now and again. Turned off engine and restarted and all ok except car spanner light stayed on.
Took it to garage and it showed the following errors on his diagnostic box...

P0340 - Camshaft sensor no signal
P0340 - Camshaft sensor incorrect signal
P0335 - Crankshaft sensor - incorrect signal
P0335 - Crankshaft sensor no signal
P0700 MIL Request fromTransmission Control Module.

Garage cleared codes and car was fine for about 2 weeks then it occured again, same fault (limp mode) and codes. again, turning off engine fixes limp mode fault!!!
Garage want to replace all items with fault codes!!!!!
Can anyone please help