1
Omega General Help / Re: Omega V6 engine bay wiring
« on: 17 December 2009, 18:08:10 »
ICV all working fine and plugged in ( not that type of connector anyway )
- 01 November 2025, 01:42:54
- Welcome, Guest
News:
Welcome to OOF
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Omega General Help / Re: Omega V6 engine bay wiring
« on: 17 December 2009, 18:07:02 »
the easiest way to explain is where the main part of the loom heads towards the fusebox its underneath that, there is currently a EML light on ( code read it in the morning now ) but this maybe down to a problem on the cam sensor, it got caught on removal,
3
Omega General Help / Re: Omega V6 engine bay wiring
« on: 17 December 2009, 17:53:06 »
to dark to count pins at mo, yes it does start and run, I know it's not the cam sensor ( that plugs at the end of the loom ), and it's not the TPS either, I'm actually thinking knock sensor mite be a option, I'm going to have a look in the morning, I blame it for being cold
4
Omega General Help / Re: Omega V6 engine bay wiring
« on: 17 December 2009, 16:42:44 »
plugged in, not that one?
5
Omega General Help / Omega V6 engine bay wiring
« on: 17 December 2009, 16:38:48 »
I've just replaced the Thermostat on a V6 Omega B, on putting everything back together I've got a lonly plug, I'm sure I've missed something?? the plug is coming from the loom on the N/S bank near the dipstick, I cant find a wire to plug into it and I have totally forgotten if it was or not plugged in before, a picture could be really handy, it's the short Male plug that comes from the loom?
just hope it's not under the manifold!!!
just hope it's not under the manifold!!!
Pages: [1]