Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: [1]   Go Down

Author Topic: Qmax arrived - time to cut the panel!  (Read 832 times)

0 Members and 1 Guest are viewing this topic.

JamesV6CDX

  • Omega Queen
  • *****
  • Offline Offline
  • Gloucestershire/Buckinghamshire
  • Posts: 16640
    • Omega 3.2 Retail MV6 LPG
    • View Profile
Qmax arrived - time to cut the panel!
« on: 25 June 2008, 11:24:43 »
Well it's here!

I presume I drill an initial central hole for the bolt, and then just put one bit each side, and do up the big one?  ::)

Very nervous here  ;D
Logged

Kevin Wood

  • Global Moderator
  • *****
  • Offline Offline
  • Gender: Male
  • Alton, Hampshire
  • Posts: 36418
    • Jaguar XE 25t, Westfield
    • View Profile
Re: Qmax arrived - time to cut the panel!
« Reply #1 on: 25 June 2008, 11:28:18 »
You could practice on the "Satan CDX" first?

Kevin
Logged
Tech2 services currently available. See TheBoy's price list: http://theboy.omegaowners.com/

JamesV6CDX

  • Omega Queen
  • *****
  • Offline Offline
  • Gloucestershire/Buckinghamshire
  • Posts: 16640
    • Omega 3.2 Retail MV6 LPG
    • View Profile
Re: Qmax arrived - time to cut the panel!
« Reply #2 on: 25 June 2008, 11:56:30 »
I've done it - it's made a lovely hole, so smooth I can run my fingers inside it :y

Phew, sweat over ;D

Any good rustproofing tips before I fit the filler? :y
Logged

Marks DTM Calib

  • Administrator
  • *****
  • Offline Offline
  • Gender: Male
  • West Bridgford
  • Posts: 34018
  • Git!
    • View Profile
Re: Qmax arrived - time to cut the panel!
« Reply #3 on: 25 June 2008, 11:57:52 »
Grease is probably the best answer.

I was going to add that I put a fine wipe of grease on the hole cutter threads and a spray of cutting oil on the cutter.....but you have already cut the hole  :y
Logged

Lazydocker

  • Omega Queen
  • *****
  • Offline Offline
  • Gender: Male
  • Woodbridge, Suffolk
  • Posts: 18848
  • Constantly Bullied by a certain Admin
    • View Profile
Re: Qmax arrived - time to cut the panel!
« Reply #4 on: 25 June 2008, 18:08:22 »
Quote
I've done it - it's made a lovely hole, so smooth I can run my fingers inside it :y

Phew, sweat over ;D

Any good rustproofing tips before I fit the filler? :y

Jeremy mentioned some kind of sealant but I can't remember what!!!  ::) ::) ::) ::)

I haven't got to worry because he's said he'll cut my hole and fit the filler for me!!!  :y :y :y :y :y
Logged
Whatever it is... I didn't do it
Pages: [1]   Go Up
« previous next »
 

Page created in 0.032 seconds with 17 queries.