Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[bigtow]

where can i get some pins to fit into the plug that goes into the ecu as i want to finally get round to retro fitting cruise control to my car ?

[TheBoy]

Why are you pissing around with pins and looms? Cruise on a 2.2/2.6/3.2 is a software setting

[05omegav6]

The extra plug on the stalk goes to the spare plug on left of column, clutch switch is a push fit with a locking collar and plug the plug in, then a little chat with Tech 2 to make it work

[bigtow]

my car was converted to manual so the ecu wants a clutch switch feed as its running a auto loom and manual ecu

[05omegav6]

Then just connect the pins from the clutch switch to the brake switch using mr haynes as reference think they're on the same circuit

[05omegav6]

Then just connect the pins from the clutch switch to the brake switch using mr haynes as reference think they're on the same circuit

[bigtow]

i did look at the how too and it says you need to put a feed to pin 21 of the ecu even if you bridge the connections at the pedals 

[05omegav6]

i did look at the how too and it says you need to put a feed to pin 21 of the ecu even if you bridge the connections at the pedals

I dread to think which guide you read try this one

http://www.omegaowners.com/forum/index.php?topic=90577.0

[bigtow]

thanks al but thats for non butchered cars autos dont need the ecu to know when the clutch is engaged or disengaged but a manual ecu does and here in lies my problem the auto loom doesnt have the required wire to feed the ecu the correct information regarding the clutch so even if i follow the guide you used the ecu still wont activate the cruise control . it was thanks to marksdtm and TB that i found this out hence why i need a new pin to fit into the empty hole in the ecu plug once thats done then it will be the same as the guide 

[05omegav6]

You could therefore fit an auto ecu and ignore the clutch switch altogether

[bigtow]

but would that not involve reprogramming the key immobilizer ect and then you have the problem of the ecu not being able to talk to the gearbox ecu ?   

[05omegav6]

Lack of autobox pops a message on the MID, only need the chip and transponder ring for the auto ecu

Alarm and remote unaffected

[bigtow]

ok will look into that once i sort the miss fire out

[tigers_gonads]

If the clutch switch works the same circuit as the brake, can you not just fit the clutch switch and wire it up in parallel to the brake switch ?
Saves ripping the ecu loom apart

[TheBoy]

I cannot recommend installing cruise without the clutch switch, doing so would be a bit brain dead.

So you need to Tech2 the ECU to manual, and install the wiring and fit the clutch switch.