Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[RobG]

Quite a few posts (and solutions) about incorrect wiper parking so this may help.

Ideally the fix is a lot easier with linkage/motor removed from car, (wipers & scuttle off, multi-plug & 4 hex fixings holding linkage)

Linkage/motor removed


Prise the link arm from the ball using a suitable bar/screwdriver


Remove the 13mm nut & star washer securing the arm to the motor


Remove arm from spline and re-align between the two marks


Through experience I tend to align the edge of the arm as near to the straight line in the casting


Replace the old nut with a "Nyloc" but if re-using I`d recommend a smear of threadlock.

Re-fit motor/linkage, scuttle & wiper arms, job done.