Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[frenchtony]

Hi
all was well with the cd stacker unit, then it stopped reading the discs, I ejected the cartridge, checked the discs, all look ok but now the cartridge wont stay in, it just springs back out immediately, no clicks or anything.

Anyone with any ideas?

[TheBoy]

I'd say either mech is bent, or come mechanically out of sync.

Either way, a fiddly, tedious and often unsuccessful repair

[radelet]

I have same same problem ! My ncdc2015 played cd fine, i wanted to change disk in magazin it ejected fine, i put new cd in magazin and when I put it back in the unit dont wont to take it whot shall I do ?

[TheBoy]

I have same same problem ! My ncdc2015 played cd fine, i wanted to change disk in magazin it ejected fine, i put new cd in magazin and when I put it back in the unit dont wont to take it whot shall I do ?

There is a guide in our Maintenence Guides section for swapping over the CDC3. If the mech is bent, or out of sync, I'd acquire a known good CDC3 and swap it over. Use your existing horizontal CDC3 I/O board, as its security coded.

[radelet]

I open my unit and fix mechanisam, now its working again