Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please play nicely.  No one wants to listen/read a keyboard warriors rants....

Pages: [1]   Go Down

Author Topic: Edge on paint  (Read 1244 times)

0 Members and 1 Guest are viewing this topic.

pauls

  • Omega Baron
  • *****
  • Offline Offline
  • Gender: Male
  • By the sea minehead
  • Posts: 2091
    • Bmw x3
    • View Profile
Edge on paint
« on: 12 March 2014, 19:36:42 »
Can anyone give me some advice. I was painting a rust repair and i had the tape to close and i now have a edge on it. Is is possible to blend this in and if so how.
Logged
..

05omegav6

  • Guest
Re: Edge on paint
« Reply #1 on: 12 March 2014, 19:42:56 »
2000 grit wet and dry, with light pressure and loads of water :y
Logged

Nick W

  • Omega Queen
  • *****
  • Offline Offline
  • Gender: Male
  • Chatham, Kent
  • Posts: 11078
    • Ghastly 1.0l Focus
    • View Profile
Re: Edge on paint
« Reply #2 on: 12 March 2014, 19:46:43 »
And always use the paper on a block! That doesn't have to be anything fancy; a piece of plywood, UPVC window trim is good, or pipe insulation for  curves.
Logged

05omegav6

  • Guest
Re: Edge on paint
« Reply #3 on: 12 March 2014, 20:08:35 »
If it's only a slight lip, cutting compound might suffice, but best with very wet and dry :y
Logged

pauls

  • Omega Baron
  • *****
  • Offline Offline
  • Gender: Male
  • By the sea minehead
  • Posts: 2091
    • Bmw x3
    • View Profile
Re: Edge on paint
« Reply #4 on: 12 March 2014, 21:15:43 »
I did think of wet and dry but wont that rub the laguer off as well
Logged
..

05omegav6

  • Guest
Re: Edge on paint
« Reply #5 on: 12 March 2014, 21:24:47 »
Be gentle, but you can give it a very light dusting of laquer once clean and dry just to seal it :y
Logged

cem_devecioglu

  • Guest
Re: Edge on paint
« Reply #6 on: 12 March 2014, 22:08:50 »
a piccy would be helpful..

if there is an edge 2000 wet sanding can correct the problem however, shape and (if ther is any) level difference may require some bondo than sanding :-\
Logged

Nick W

  • Omega Queen
  • *****
  • Offline Offline
  • Gender: Male
  • Chatham, Kent
  • Posts: 11078
    • Ghastly 1.0l Focus
    • View Profile
Re: Edge on paint
« Reply #7 on: 13 March 2014, 11:23:31 »
Quote from: pauls on 12 March 2014, 19:36:42
Can anyone give me some advice. I was painting a rust repair and I had the tape too close and i now have a edge on it. Is is possible to blend this in and if so how.

Next time use a wider tape, and gently curve it back over itself away from the repair. This will help you get a much softer edge on the new paint.
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.01 seconds with 17 queries.