Topic: In the market for a looooong 1/2" drive ratchet. Any recommendations? (Read 2768 times)

Webby the Bear · « **Reply #15 on:** 17 April 2015, 17:14:00 »

Thanks for the replies guys.

As over nicks post. . . Long ratchet is so useful. E.g. Caliber Carrie bolts. Yes it breaks loose but they're still FT and a short ratchet is a pain.

chrisgixer · « **Reply #16 on:** 17 April 2015, 23:02:33 »

Re caliper carrier bolts, I find if you turn the steering so the calliper side of the wheel points outboard, once loosened, you can get an electric impact wrench on the bolts and just wiz them out.

Need to be careful nobody is working on the other side though.

Webby the Bear · « **Reply #17 on:** 18 April 2015, 02:32:07 »

completely agree cg. but a lot of time there is

chrisgixer · « **Reply #18 on:** 18 April 2015, 09:42:46 »

Quote from: Webby the Bear on 18 April 2015, 02:32:07

completely agree cg. but a lot of time there is

Well make him wait two seconds, do yours, then pass him the whizzy.

Webby the Bear · « **Reply #19 on:** 21 April 2015, 21:08:12 »

Thanks for all the replies.

Well, cost has played a bit of a part. . . Going to try the ratchet adapter that martin mentioned. Cheers mate for the idea

News:

Author Topic: In the market for a looooong 1/2" drive ratchet. Any recommendations? (Read 2768 times)

Webby the Bear

Re: In the market for a looooong 1/2" drive ratchet. Any recommendations?

chrisgixer

Re: In the market for a looooong 1/2" drive ratchet. Any recommendations?

Webby the Bear

Re: In the market for a looooong 1/2" drive ratchet. Any recommendations?

chrisgixer

Re: In the market for a looooong 1/2" drive ratchet. Any recommendations?

Webby the Bear

Re: In the market for a looooong 1/2" drive ratchet. Any recommendations?