Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[davieboy0312]

Hi guys. Firstly thanks to al advice on finding what plugs go where on my engine after losing the list I made to help put it all back together again. But I have 3 plugs I cant find info about

1- 2 pin plug. Red with blue track/ brown with black track
2- 2 pin plug. Blue with red track/ brown with green track
3- 2 pin red plug. Red with blue track/ brown with red track

Thanks guys I am stumped here

[05omegav6]

Approximately where are the plugs

[davieboy0312]

if I was to hazard a guess al I would think roughly drivers side middle to rear. one of the plugs is red in colour

[05omegav6]

Without looking... And having never had a 3.0, I would suggest them being...

Oil level sensor loom
Ecu coolant temp
Purge valve

The last two being possible to swap with no ill effects until you realise and swap them back... At this point you realise that he Ecu sensor is cooked

[davieboy0312]

oil level sensor is on a separate loom already got that one sorted. purge valve where does that live? is the coolant temp live on the coolant bridge? next to the other coolant sensor with the one wire on it? found that one too

[Andy89]

Here is the purge valve

[davieboy0312]

that's definitely a red plug andy you wouldn't happen to have a pic of the purge valve would you to see if I can find mine? thanks mate 2 left to go!!!

[Andy89]

It is the purge valve you see there, but here's a better picture 

Red circle: Purge valve
Orange circle: Coolant temp for the tacho
Yellow circle: Coolant temp for the ECU

These three connectors exit on the same location on the wiring loom

[davieboy0312]

thanks mate now gotta find what I done with the purge valve.

do you think the other ones could be the secondary water pump? and the bonnet alarm thing?

[Andy89]

I don't know where the rest are located, but if this is engine loom only, then no.

[davieboy0312]

yea its only engine loom. totally stumped. cant find them on Haynes manual.

[Andy89]

If you go through the wiring diagram in the back you can 
Are the ones you are missing all at the back of the engine?

[davieboy0312]

at a guess I would say in the same kind of area as purge valve/ drivers side

[Andy89]

Do the ones you miss come directly out of the square plastic thing, or the tube longer down? (the three that comes out longer down the tube are all for the ones i pictured)
Can you take a picture?

[davieboy0312]

the other ones you have pictured I have found. when the loom was removed the material holding the loom together was ripped and torn and falling apart so hard to tell where they originally came from. but they are the three longest plug wires on the loom. just a tad shorter than the 2 lambda sensor plugs