Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: [1] 2  All   Go Down

Author Topic: What to do with this?  (Read 6359 times)

0 Members and 1 Guest are viewing this topic.

Sir Tigger KC

  • Get A Life!!
  • *****
  • Offline Offline
  • Gender: Male
  • West Dorset
  • Posts: 24953
    • BMW 530d Touring
    • View Profile
What to do with this?
« on: 27 September 2015, 16:16:37 »


These are the LPG injector wires that were melted on the SAI pipe.  Should I cut out the melted bits either side back to good insulation and put in some new wire with connectors or just re insulate with tape?  :-\
Logged
RIP Paul 'Luvvie' Lovejoy

Politically homeless ......

05omegav6

  • Guest
Re: What to do with this?
« Reply #1 on: 27 September 2015, 18:00:30 »
Daft brush... ::)

Obviously repair it properly with solder and heat shrink :y

Do one wire at a time to avoid chaos though :D
Logged

Nick W

  • Omega Queen
  • *****
  • Offline Offline
  • Gender: Male
  • Chatham, Kent
  • Posts: 11077
    • Ghastly 1.0l Focus
    • View Profile
Re: What to do with this?
« Reply #2 on: 27 September 2015, 20:19:28 »
It's probably better, easier and neater to replace from the melted part to wherever they go.
Logged

Sir Tigger KC

  • Get A Life!!
  • *****
  • Offline Offline
  • Gender: Male
  • West Dorset
  • Posts: 24953
    • BMW 530d Touring
    • View Profile
Re: What to do with this?
« Reply #3 on: 27 September 2015, 21:04:09 »
Quote from: Nick W on 27 September 2015, 20:19:28
It's probably better, easier and neater to replace from the melted part to wherever they go.

Back to the LPG systems ECU I presume.  :-\  Maybe it goes back to a plug and I can pull the whole lot out.  :-\

Anyway as I don't have a soldering iron, it'll get wrapped in insulating tape for the time being.  ;)
Logged
RIP Paul 'Luvvie' Lovejoy

Politically homeless ......

05omegav6

  • Guest
Re: What to do with this?
« Reply #4 on: 27 September 2015, 21:07:55 »
Oh lordy, lordy, lordy... ;D
Logged

henryd

  • Omega Lord
  • *****
  • Offline Offline
  • Gender: Male
  • west cornwall
  • Posts: 8810
  • VW Touareg R5 tdi Auto
    • View Profile
Re: What to do with this?
« Reply #5 on: 01 October 2015, 11:56:02 »
Quote from: Sir Tigger on 27 September 2015, 16:16:37


These are the LPG injector wires that were melted on the SAI pipe.  Should I cut out the melted bits either side back to good insulation and put in some new wire with connectors or just re insulate with tape?  :-\

Looks a bit of a mucking fess does that :o :o
Logged
other rides 
  mk3 Volvo v70 2.0 Diesel ,Citroen C2, Pug 306 cabriolet
  Sterling elite trekker pikey wagon

Diamond Black Geezer

  • Omega Lord
  • *****
  • Offline Offline
  • Gender: Male
  • N E Lincolnshire & Warwickshire
  • Posts: 5719
  • Diamond Black '96 CDX V6 - 'Pissy'
    • & a silly coupe coming...
    • View Profile
Re: What to do with this?
« Reply #6 on: 01 October 2015, 14:24:30 »
In theory you can insulating tape over it, then get some of that cloth tape that you see all over the engine bay, then ideally a ribbed shroud, maybe like the stuff that you get on the crank sensor, and that'll be fine. Of course ideally you want to solder in fresh wire, then do all of the above. (heatshrink replacing insulating tape of course)

Got some old previous-owner electrical bodges which I'm after sorting too; myself.  :)
Logged
Ex-Dealer Kent-Moore Rear Wheel Bearing Tool available for hire, PM for details.

"There's no point in being grown up if you can't be childish sometimes." 4th Doctor

Sir Tigger KC

  • Get A Life!!
  • *****
  • Offline Offline
  • Gender: Male
  • West Dorset
  • Posts: 24953
    • BMW 530d Touring
    • View Profile
Re: What to do with this?
« Reply #7 on: 01 October 2015, 22:47:03 »
Well I ended up double wrapping each wire with insulating tape and then wrapping the whole lot before putting it in a length of the black plastic ribbed shroud and normal service has been resumed.  :y

Of course I will at some point do a proper job with solder, heatshrink and new wiring.  ::)
Logged
RIP Paul 'Luvvie' Lovejoy

Politically homeless ......

05omegav6

  • Guest
Re: What to do with this?
« Reply #8 on: 02 October 2015, 06:19:53 »
Quote from: Sir Tigger on 01 October 2015, 22:47:03
Well I ended up double wrapping each wire with insulating tape and then wrapping the whole lot before putting it in a length of the black plastic ribbed shroud and normal service has been resumed.  :y

Of course I will at some point do a proper job with solder, heatshrink and new wiring.  ::)
Yeah right ::) you'll have forgotten by Saturday :D
Logged

Sir Tigger KC

  • Get A Life!!
  • *****
  • Offline Offline
  • Gender: Male
  • West Dorset
  • Posts: 24953
    • BMW 530d Touring
    • View Profile
Re: What to do with this?
« Reply #9 on: 02 October 2015, 23:40:06 »
Forgotten what?  :-\
Logged
RIP Paul 'Luvvie' Lovejoy

Politically homeless ......

05omegav6

  • Guest
Re: What to do with this?
« Reply #10 on: 03 October 2015, 07:56:02 »
 ::) the remembering to fix it properly... :y
Logged

Sir Tigger KC

  • Get A Life!!
  • *****
  • Offline Offline
  • Gender: Male
  • West Dorset
  • Posts: 24953
    • BMW 530d Touring
    • View Profile
Re: What to do with this?
« Reply #11 on: 03 October 2015, 10:39:32 »
Fix what?  :-\
Logged
RIP Paul 'Luvvie' Lovejoy

Politically homeless ......

05omegav6

  • Guest
Re: What to do with this?
« Reply #12 on: 03 October 2015, 11:47:52 »
Quote from: Sir Tigger on 03 October 2015, 10:39:32
Fix what?  :-\
The high resistance, heat soaked wiring freshly wrapped in insulation tape...
Logged

Sir Tigger KC

  • Get A Life!!
  • *****
  • Offline Offline
  • Gender: Male
  • West Dorset
  • Posts: 24953
    • BMW 530d Touring
    • View Profile
Re: What to do with this?
« Reply #13 on: 03 October 2015, 14:56:25 »
Quote from: Harris K Telemacher on 03 October 2015, 11:47:52
Quote from: Sir Tigger on 03 October 2015, 10:39:32
Fix what?  :-\
The high resistance, heat soaked wiring freshly wrapped in insulation tape...

Oh that's fixed!  :y               For now.....  ::)  ;D
Logged
RIP Paul 'Luvvie' Lovejoy

Politically homeless ......

biggriffin

  • Omega Lord
  • *****
  • Offline Offline
  • huntingdon, Hoof'land
  • Posts: 9848
    • It's Insignificant
    • View Profile
Re: What to do with this?
« Reply #14 on: 03 October 2015, 15:47:42 »
Quote from: Sir Tigger on 03 October 2015, 14:56:25
Quote from: Harris K Telemacher on 03 October 2015, 11:47:52
Quote from: Sir Tigger on 03 October 2015, 10:39:32
Fix what?  :-\
The high resistance, heat soaked wiring freshly wrapped in insulation tape...

Oh that's fixed!  :y               For now.....  ::)  ;D

Tiggers had the insulation tape out today then  :D
Logged
Hoof'land storeman.
Pages: [1] 2  All   Go Up
« previous next »
 

Page created in 0.011 seconds with 17 queries.