Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: [1]   Go Down

Author Topic: V6 2.6 Engine Errors lights  (Read 1191 times)

0 Members and 1 Guest are viewing this topic.

SBuffo

  • Newbie
  • *
  • Offline Offline
  • Gender: Male
  • North West England
  • Posts: 5
    • Omega 2.6 V6 CDX
    • View Profile
V6 2.6 Engine Errors lights
« on: 16 June 2016, 19:26:06 »
Hi and help.  Have a 03 reg 2.6 V6 auto.  Can anyone guide me to a reliable wiring diagram?  I have problem with engine management and emission lights coming on (spanner and engine) and then going away sometimes.  Currently emission light on most of the time.  Months ago had new cambelt and new coils.  When this lights problem first happened got a new crank sensor.. could that be "Wrong?".   Any help with wiring diagram or ideas of what to look at .. Pedal trick gives 0420, 0430 and 0340, 0330   ................S Buffo  P.S. occasionally get the low beam check error message coming on
Logged

Doctor Gollum

  • Get A Life!!
  • *****
  • Offline Offline
  • Gender: Male
  • In a colds and darks puddleses
  • Posts: 30330
  • If you can't eat them, join them...
    • Feetses.
    • View Profile
Re: V6 2.6 Engine Errors lights
« Reply #1 on: 16 June 2016, 20:05:51 »
0420/0430 are almost factory fitted. Wynns fuel treatment, a couple of tanks of VPower and a heavy right foot usually solve that.

As for the rest... where did the crank sensor come from? Please don't say ebay or Autovaux.

Low beam is most likely a disconnected arm on either the front or rear sensor... both on lefthand side, usually the front one is to blame ;)
Logged
Onanists always think outside the box.

SBuffo

  • Newbie
  • *
  • Offline Offline
  • Gender: Male
  • North West England
  • Posts: 5
    • Omega 2.6 V6 CDX
    • View Profile
Re: V6 2.6 Engine Errors lights
« Reply #2 on: 22 June 2016, 18:14:47 »
Many thanks
I've had to leave it a day or two but back now chasing issues...
Would this also explain why the engine cuts out after say 7 miles, temp up to 80 ish on the gauge, than restarts with lots of right foot and runs ok if the temp stays above 85 ish.
Got a 0100 error when "pedal checked"....

Got local garage to fit new crank sensor - so Should/better had be OK....

Its a great car when it goes well so am persevering!
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.015 seconds with 17 queries.