Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[JDX]

Did I hear my name being taken in vain.  …………………………...
Unfortunately I don't have one. Had to buy a new one for my own car not long after I bought it. Iirc it cost about £90.
Mr Alnico - if its easier for you, drop one off to me at work and I will take it to JDX. I reckon that would save you about 40 miles on the return journey.

This one looks like good value then?......
https://www.ebay.co.uk/itm/Vauxhall-OMEGA-VECTRA-3-2-2-6-V6-IGNITION-MODULE-COIL-PACK-NEW-9118115/311292987580

[JDX]

OK thanks.
When I changed the plugs the spark plug holes were full of water on that side, so maybe that started the problem. I have since sealed the scuttle so hopefully it wont happen again.
I will have ago at checking the sparks on that side tomorrow in the daylight.

Water in no. 6 from leak in the scuttle will cause a misfire. It doesn't often get into 4 and 2, but oil does from a leaking cam cover gasket.

The water had got into 2,4 & 6 unfortunately. The car has been sat idle for quite a while outside & not undercover....hey ho!

[TheBoy]

Rather than the scuttle leaking, its far more likely that the lower edge of the windscreen seal isn't fully attached, so you'll want to be checking that before fitting and potentially ruining a new coil pack.

[TheBoy]

For the P1110, make sure you've plugged in the rear multiram, and that its connectors are clean.

[JDX]

For the P1110, make sure you've plugged in the rear multiram, and that its connectors are clean.

Thanks.
I did really struggle to connect it before. I had somehow managed to bend one of the pins & it wasn't connected properly. I will take it off again & make sure the connectors are clean. I will also check out the windscreen. 

[JDX]

So, if there are small cracks on the hard plastic oblong shaped part which is attached to the rubber spark plug boot, I'm assuming the pack is a gonna?
(Iv'e taken a picture but am useless at getting them on here)

[Doctor Gollum]

The cracks are caused by heat soak, these then allow water in which causes the plates inside to rust and separate which causes the plastic case to split... It's a self fulfilling prophecy...

246 side always goes first as the bulkhead foam above the coil pack holds about a pint of water which it drips onto the coilpack.

The seal is as much about keeping dirt out of the plug wells as water... Unfortunately it is not a very good seal

[JDX]

Thanks DG, I will get a new one then.
With regards to the bulkhead foam, if it's wet under the drivers side wiper arm hole, would that run across the foam onto the passenger side? It seems unlikely to me. I'm not certain where the water would have come from yet. The seal between the windscreen & the scuttle seems to fit really well, the foam above the passenger side is really dry when you push on it there is no moisture on your hand at all. 

[Doctor Gollum]

If it had been the driver's side the 135 would have been affected 

That said there's also foam underneath the scuttle trim... But water tends to run down the seam at the filler panel that form the inboard end of the pollen filter housing.

[JDX]

If it had been the driver's side the 135 would have been affected 

That said there's also foam underneath the scuttle trim... But water tends to run down the seam at the filler panel that form the inboard end of the pollen filter housing.

Right, thanks, good to know...

[TheBoy]

Thanks DG, I will get a new one then.
With regards to the bulkhead foam, if it's wet under the drivers side wiper arm hole, would that run across the foam onto the passenger side? It seems unlikely to me. I'm not certain where the water would have come from yet. The seal between the windscreen & the scuttle seems to fit really well, the foam above the passenger side is really dry when you push on it there is no moisture on your hand at all. 

The leak will be between the windscreen and the seal.  Push it back on more firmly.

[shyboy]

I once experimentally used Araldite to repair the cracks in a 246 coil pack which was causing the EML to come on intermittingly, and had no further problems with it, but I do think I was lucky and caught it at a very early stage of deterioration. Perhaps worth a try.

[cam.in.head]

Yes me too . Works fine as a repair but you just need to make sure it’s all nice and dry first. Did my 246 pack 3 years ago and been fine since.

[Migv6 le Frog Fan]

Did I hear my name being taken in vain.  …………………………...
Unfortunately I don't have one. Had to buy a new one for my own car not long after I bought it. Iirc it cost about £90.
Mr Alnico - if its easier for you, drop one off to me at work and I will take it to JDX. I reckon that would save you about 40 miles on the return journey.

This one looks like good value then?......
https://www.ebay.co.uk/itm/Vauxhall-OMEGA-VECTRA-3-2-2-6-V6-IGNITION-MODULE-COIL-PACK-NEW-9118115/311292987580

I bought genine Bosch. That one is unbranded, so could be a bit of a gamble ? 

[Doctor Gollum]

I once experimentally used Araldite to repair the cracks in a 246 coil pack which was causing the EML to come on intermittingly, and had no further problems with it, but I do think I was lucky and caught it at a very early stage of deterioration. Perhaps worth a try.

Not great with heat...