Topic: Ex plod 2002 MV6 auto cutting out (Read 3208 times)

Elite Pete · « **Reply #15 on:** 03 September 2007, 19:52:11 »

Hi Mike and welcome

Darth Loo-knee · « **Reply #16 on:** 04 September 2007, 13:08:56 »

Hi and welcome to the forum

Hugh_G_Rection · « **Reply #17 on:** 05 September 2007, 12:19:57 »

Hi,
   My 1999 MV6 had a similar problem. It turned out to be the Mass Airflow Sensor. The analogue output signal drifts up and down when the unit gets hot. This has the effect of making the mixture ratio go out of limits and the engine loses power or stops.
   The engine management computer is still receiving a signal from it, (albeit erroneous), so it does NOT light the engine management warning on the dashboard. It will log a fault code by comparison of other sensor inputs, which can be read with a fault code reader.
   A secondhand MAF sensor is about 60 - 100 quid and a new one is about 280. Bosch are aware that these thin-film type sensors have a limited lifespan, but have done very little to correct the problem.

   The crankshaft sensor on my car has just failed, so I will be joining you in the "oily hand" gang this weekend.

   Have fun.

hotel21 · « **Reply #18 on:** 05 September 2007, 13:03:39 »

Howdoo, and welcome to the forum Mick.

Martin_1962 · « **Reply #19 on:** 05 September 2007, 14:48:44 »

Hello & Welcome [smiley=thumbsup.gif]

DaveL · « **Reply #20 on:** 09 September 2007, 14:09:05 »

Hello & welcome

8-)
DaveL

News:

Author Topic: Ex plod 2002 MV6 auto cutting out (Read 3208 times)

Elite Pete

Re: Ex plod 2002 MV6 auto cutting out

Darth Loo-knee

Re: Ex plod 2002 MV6 auto cutting out

Hugh_G_Rection

Re: Ex plod 2002 MV6 auto cutting out

hotel21

Re: Ex plod 2002 MV6 auto cutting out

Martin_1962

Re: Ex plod 2002 MV6 auto cutting out

DaveL

Re: Ex plod 2002 MV6 auto cutting out