Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please play nicely.  No one wants to listen/read a keyboard warriors rants....

Pages: 1 [2]  All   Go Down

Author Topic: HT Leads Question  (Read 6171 times)

0 Members and 1 Guest are viewing this topic.

Marks DTM Calib

  • Administrator
  • *****
  • Offline Offline
  • Gender: Male
  • West Bridgford
  • Posts: 34096
  • Git!
    • View Profile
Re: HT Leads Question
« Reply #15 on: 23 July 2006, 09:50:58 »
The sensor between the MAF and air box is the air temp sensor (often built into the later MAF's).

The stub is basicaly a matching device used on transmission lines (or on this case an air system but, similar principles), it will flatten out the torque curve by absorbing air pulses from the engine.....

The Bosch leads are good, they dont seal very well with the cam cover but, that shouldn't cause to many problems as there is a cover over the top of them.
Logged

Taxi_Driver

  • Guest
Re: HT Leads Question
« Reply #16 on: 23 July 2006, 11:16:56 »
Ahh right....thanks
Logged
Pages: 1 [2]  All   Go Up
« previous next »
 

Page created in 0.01 seconds with 16 queries.