Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[M-Tek Performance]

??  long mot, tax, very good condition, wood steering wheel, everything works, leather, magnecor leads..

any ideas?  its a 3.0..

[Martin_1962]

Buying or selling

[M-Tek Performance]

its an Auto too.

selling.

[Baron Von Spongebob]

£10.50

I will have it  

[Martin_1962]

Does it have an MTEK chip?

[M-Tek Performance]

its not me selling  

[M-Tek Performance]

Does it have an MTEK chip?

no lol.  its standard as you like!

[Martin_1962]

Offer them £500 and drop your chip in

[M-Tek Performance]

Offer them £500 and drop your chip in

im not buying it..

[Martin_1962]

Offer them £500 and drop your chip in

im not buying it..

Getting a tractor then?

[M-Tek Performance]

Offer them £500 and drop your chip in

im not buying it..

Getting a tractor then?

I dont know, but i have to weigh up the costs.

the link you gave me is great, but its extra bits i need thats causing the problem, and the fitting of it myself..

[Martin_1962]

Offer them £500 and drop your chip in

im not buying it..

Getting a tractor then?

I dont know, but i have to weigh up the costs.

the link you gave me is great, but its extra bits i need thats causing the problem, and the fitting of it myself..

Don't be scared. We are here to help.

You could wait on the James project or just have a go

[M-Tek Performance]

If i get a petrol one, it has to be converted ASAP as i do far too many miles to not run it on gas.

[Martin_1962]

If i get a petrol one, it has to be converted ASAP as i do far too many miles to not run it on gas.

Do you have the following?

Good mechanical knowleage
A laptop (I didn't - my home PC moaned for ages over USB things)
Pipe bender (cheap off Ebay)
34mm or was it 38mm hole drill - I chain drilled!!!!
Tap set - I think M8 is required
6.5mm drill
Or able to drill manifold may need pillar drill, I used B&D on the plenum
Soldering kit
heat shrink tubing
Enough 6mm and 8mm LPG pipe.

[M-Tek Performance]

Do you have the following?

Good mechanical knowleage  - My brother / Business Partner does have more than me
A laptop (I didn't - my home PC moaned for ages over USB things) - yup - i use it for mapping
Pipe bender (cheap off Ebay) - I have access to a pipe bender
34mm or was it 38mm hole drill - I chain drilled!!!! - I can get one
Tap set - I think M8 is required - As above lol
6.5mm drill - yes
Or able to drill manifold may need pillar drill, I used B&D on the plenum - my dad's an engineer so should be fine
Soldering kit - yes
heat shrink tubing - yes
Enough 6mm and 8mm LPG pipe. - no - dont know what lpg pipe is either