mine misses both ways? and it sticks out about a foot from the glass? has done this since I washed it last?
Yours is an estate, most of them do this. It's annoying, but possible to get right with a bit of faffing!
Firstly, I would remove the whole arm and give a damn good clean in the kitchen sink, the spring gets crudded up where it mounts and it seems to be less 'pliable'. Give the blade a good wash and brush, again, it gets stiff where the 'pivot' points are (replace if necessary). Then i'd give all the joints on the blade a good old flexing past their usual travel to free them up. Make sure it's nice and dry then apply a drop of oil on all joints. Refit, hope for the best and get ready to do it again a couple of months down the line!

(Stand and admire the rusty rear wiper arm as well

)
.....and only buy genuine VX wipers. Others don't work. Cheap on Trade Club as well
