Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: [1]   Go Down

Author Topic: Bolts or Torque screws for bumper?  (Read 914 times)

0 Members and 1 Guest are viewing this topic.

Senninha

  • Newbie
  • *
  • Offline Offline
  • Gender: Male
  • Near Norwich
  • Posts: 22
  • Driven To Perfection!
    • View Profile
Bolts or Torque screws for bumper?
« on: 18 November 2007, 00:41:41 »
Hi everyone!
I have a facelift irmscher rear bumper on my pre facelift Omega, and I was wondering what went on where as the bracket holes are the other way on the wheelarch liner at the bottom of the bumper,
Could someone confirm that there is brackets, and you have to use nuts and bolts instead of torque screws with the screw clamps? :-/

Incase any of you are wondering Im just replacing the impact beam which is rusty and bolts/nuts which are very rusty!  ;D
Any pictures would be handy :)
« Last Edit: 18 November 2007, 00:42:35 by Senninha »
Logged

STMO123

  • Guest
Re: Bolts or Torque screws for bumper?
« Reply #1 on: 18 November 2007, 11:57:51 »
Anyone?
Logged

Marks DTM Calib

  • Administrator
  • *****
  • Offline Offline
  • Gender: Male
  • West Bridgford
  • Posts: 34018
  • Git!
    • View Profile
Re: Bolts or Torque screws for bumper?
« Reply #2 on: 18 November 2007, 12:20:19 »
A bit of a mix....some torx screws and a few clips from memory.

The bumper iron is bolted on.
Logged

Senninha

  • Newbie
  • *
  • Offline Offline
  • Gender: Male
  • Near Norwich
  • Posts: 22
  • Driven To Perfection!
    • View Profile
Re: Bolts or Torque screws for bumper?
« Reply #3 on: 18 November 2007, 18:22:45 »
Quote
A bit of a mix....some torx screws and a few clips from memory.

The bumper iron is bolted on.

How do you mean iron is bolted on?
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.016 seconds with 16 queries.