Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: [1]   Go Down

Author Topic: Secondary air pump relay voltage high  (Read 696 times)

0 Members and 1 Guest are viewing this topic.

billfxtwo

  • Newbie
  • *
  • Offline Offline
  • Gender: Male
  • Plymouth
  • Posts: 11
    • View Profile
Secondary air pump relay voltage high
« on: 08 May 2008, 12:39:34 »
Hi, could anyone please tell me where the Secondary air pump relay is located and what the symptoms are when it’s not working properly the fault code is P0410,  Cheers Bill
Logged

rickyboy

  • Senior Member
  • ****
  • Offline Offline
  • Gender: Male
  • Glasgow
  • Posts: 807
    • View Profile
Re: Secondary air pump relay voltage high
« Reply #1 on: 08 May 2008, 13:48:29 »
Can you update your profile details so we know what car you have?  It'll make helping you a lot easier.

2.0/2.2/2.5/2.6/3.0/3.2?
Logged

bighed

  • Senior Member
  • ****
  • Offline Offline
  • Gender: Male
  • Shropshire
  • Posts: 883
    • View Profile
Re: Secondary air pump relay voltage high
« Reply #2 on: 09 May 2008, 02:07:17 »
It not working should not have any effect on the running of the engine as all this does is "warms" the cats on start up to comply with euro 3 emissions. Loo-knee has totally disconnected his of swmbo's mig!!  :y
Logged

rickyboy

  • Senior Member
  • ****
  • Offline Offline
  • Gender: Male
  • Glasgow
  • Posts: 807
    • View Profile
Re: Secondary air pump relay voltage high
« Reply #3 on: 09 May 2008, 08:04:58 »
All the relays on the 2.0 l can be found next to the ecu in the box behind the battery if I recall correctly.  Don't know which one is which but there is only a few in there so you could test them all to see if they're working correctly.
Logged

Matchless

  • Omega Knight
  • *****
  • Offline Offline
  • Gender: Male
  • Nottingham
  • Posts: 1563
    • A white van
    • View Profile
Re: Secondary air pump relay voltage high
« Reply #4 on: 09 May 2008, 12:33:18 »
I think this code is raised if the connector to the vacuum solenoid (on radiator, rhs) is disconnected or if the solenoid coil is open circuit.
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.012 seconds with 16 queries.