Topic: Torque settings for rocker covers (Read 816 times)

madbiker · « **on:** 18 October 2008, 17:39:17 »

HELLLLLPPPPP. Iv just found out my torque wrench dont go down to 8nm Is this the right torque for rocker covers?

?? If so is there anyway of guesstimating this torque???

TheBoy · « **Reply #1 on:** 18 October 2008, 17:44:52 »

8Nm. Difficult to judge without. Get it wrong, and they will likely leak again

madbiker · « **Reply #2 on:** 18 October 2008, 17:50:15 »

Ok looks like a trip to halfords 2moro then. Thanks 8-) 8-)

Clouseau · « **Reply #3 on:** 19 October 2008, 12:22:32 »

Get the £49.99 3/8 torque wrench which is excellent and will dial down to 8NM. I cheekily asked if they could knock a bit off the price and they gave me 20% off!

PaulW · « **Reply #4 on:** 19 October 2008, 15:46:44 »

My torque wrench only went down to 10nm, but that seemed to work fine when I did mine...

Covers don't leak, put it that way

its just the damned head/block seal which does

News:

Author Topic: Torque settings for rocker covers (Read 816 times)

madbiker

Torque settings for rocker covers

TheBoy

Re: Torque settings for rocker covers

madbiker

Re: Torque settings for rocker covers

Clouseau

Re: Torque settings for rocker covers

PaulW

Re: Torque settings for rocker covers