Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to OOF

Pages: [1]   Go Down

Author Topic: rpm sensor fault  (Read 1484 times)

0 Members and 1 Guest are viewing this topic.

mondo76

  • Newbie
  • *
  • Offline Offline
  • Gender: Male
  • poole
  • Posts: 36
    • View Profile
rpm sensor fault
« on: 12 October 2008, 13:42:16 »
hi all thanx for lkooking , im getting a rpm sensor fault from time to time , comes and goes , anyone had this problem before , any ideas , cheers again
Logged

Albatross

  • Omega Baron
  • *****
  • Offline Offline
  • Gender: Male
  • Bedford
  • Posts: 2100
  • An LSD & an S2000!
    • View Profile
Re: rpm sensor fault
« Reply #1 on: 12 October 2008, 14:12:21 »
Hi there,

It would help if you posted this in the "General Help" section rather than the newbies "Introduction" area; you'll get more help.

Interested to find out the answer because my rpm needle seems to "stick" and then "jump" occasionally too
« Last Edit: 12 October 2008, 14:12:54 by Albatross »
Logged

TheBoy

  • Administrator
  • *****
  • Offline Offline
  • Gender: Male
  • Brackley, Northants
  • Posts: 107031
  • I Like Lockdown
    • Whatever Starts
    • View Profile
Re: rpm sensor fault
« Reply #2 on: 12 October 2008, 20:29:13 »
moved to appropriate section
Logged
Grumpy old man

chrisdb

  • Intermediate Member
  • ***
  • Offline Offline
  • Gender: Male
  • Chesterfield
  • Posts: 364
    • View Profile
Re: rpm sensor fault
« Reply #3 on: 30 October 2008, 20:58:24 »
Yes, had this problme once. The rpm sensor was getting burnt out after a few weeks (was replaced about 5 times). Fault was caused because VX fitted an exhaust system badly and rpm sensor was getting cremated.

Symptoms were - engine would not rev over 2,800 rpm.
Logged
TC Card, will buy parts for members near by. V6 Camshaft locking kit can rent out to members at club rates.
Pages: [1]   Go Up
« previous next »
 

Page created in 0.01 seconds with 16 queries.