Topic: help need with breather bridge (Read 1093 times)

fife_omega_v6 · « **on:** 28 January 2009, 17:57:15 »

how the hell do you remove it???
taken out the bolt but cant get it to release from the front two pipes :-/

stuyg · « **Reply #1 on:** 28 January 2009, 18:02:20 »

you need to remove the throttle body on the front of the plenem 4 bolts (if i rember)

jjleonard · « **Reply #2 on:** 28 January 2009, 18:02:21 »

lots of wiggling and pulling. the seals go rock hard and take a considerable amount of effort to separate them - just keep pulling it and wiggle from side to side gently.

jjleonard · « **Reply #3 on:** 28 January 2009, 18:02:59 »

You can do it without removing the throttle body, but i agree - it would be easier to take it off.

Marks DTM Calib · « **Reply #4 on:** 28 January 2009, 18:43:46 »

Quote

You can do it without removing the throttle body, but i agree - it would be easier to take it off.

Only only the extended plenums you can....not on the 2.5 and early 3.0 short ones

Mike Collins · « **Reply #5 on:** 28 January 2009, 19:43:01 »

You'll probably need to raise the front og the plenum to get socket on the lower throttle body screws. Ease the body forward just enough to clear the two pipe stubs on the plastic section.

News:

Author Topic: help need with breather bridge (Read 1093 times)

fife_omega_v6

help need with breather bridge

stuyg

Re: help need with breather bridge

jjleonard

Re: help need with breather bridge

jjleonard

Re: help need with breather bridge

Marks DTM Calib

Re: help need with breather bridge

Mike Collins

Re: help need with breather bridge