Topic: Removing front section of fuel line. (Read 1102 times)

PaulW · « **on:** 13 October 2009, 12:39:11 »

How is this done exactly? I'm trying to get the lines of the Elite, yet where it goes through the front chassis component just before it goes up the front wheel arch, it goes through a few holes. These have some very very hard grommets in them, and I can't get the damn things out...

Any tips or ideas? Or is it just a case of cutting the old connectors off & fitting new ones again when fitted to another car??

Cheers

rustym95 · « **Reply #1 on:** 13 October 2009, 14:26:57 »

if yours are the rigid type, there are connectors, you have to undo them, either with the proper tool or a pair of pliers, and unclip the pipes from each other.

PaulW · « **Reply #2 on:** 13 October 2009, 17:14:07 »

Undoing them wasn't the issue, it was getting the things through the chassis rails where they are fed...

Elite Pete · « **Reply #3 on:** 13 October 2009, 17:18:59 »

Try some boiling water on the grommets Paul see if they soften up

PaulW · « **Reply #4 on:** 13 October 2009, 17:21:11 »

Got it sorted in the end Pete

No wonder they're not mentioned in the Book of Lies

News:

Author Topic: Removing front section of fuel line. (Read 1102 times)

PaulW

Removing front section of fuel line.

rustym95

Re: Removing front section of fuel line.

PaulW

Re: Removing front section of fuel line.

Elite Pete

Re: Removing front section of fuel line.

PaulW

Re: Removing front section of fuel line.