Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to OOF

Pages: [1]   Go Down

Author Topic: Aux tensioner again  (Read 649 times)

0 Members and 1 Guest are viewing this topic.

megaomega123

  • Senior Member
  • ****
  • Offline Offline
  • Gender: Male
  • 0
  • Posts: 915
    • View Profile
Aux tensioner again
« on: 01 March 2010, 17:15:09 »
Is the bolt that holds the pulley on supposed to be loose? It moves back and forth in the tensioner by about 10mm. Obviously it tightens when the pulley is on and tightened up. Just checking.
Logged
ʎɐqǝ uo pɹɐoqʎǝʞ ɐ ʎnq ı ǝɯıʇ ʇsɐן ǝɥʇ sı sıɥʇ.

Andy B

  • Get A Life!!
  • *****
  • Offline Offline
  • Gender: Male
  • Bury Lancs
  • Posts: 39728
    • ML350 TDM SmartRoadster
    • View Profile
Re: Aux tensioner again
« Reply #1 on: 01 March 2010, 17:23:42 »
Quote
Is the bolt that holds the pulley on supposed to be loose? It moves back and forth in the tensioner by about 10mm. Obviously it tightens when the pulley is on and tightened up. Just checking.

Yes, until you tighten it up!  ::)  ;)  :y If you were to remove the whole tensioner from the side of the block, the bolt would fall out.  :y
Logged

megaomega123

  • Senior Member
  • ****
  • Offline Offline
  • Gender: Male
  • 0
  • Posts: 915
    • View Profile
Re: Aux tensioner again
« Reply #2 on: 01 March 2010, 18:15:58 »
Thanks very much  :y
Logged
ʎɐqǝ uo pɹɐoqʎǝʞ ɐ ʎnq ı ǝɯıʇ ʇsɐן ǝɥʇ sı sıɥʇ.
Pages: [1]   Go Up
« previous next »
 

Page created in 0.017 seconds with 18 queries.