Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: [1]   Go Down

Author Topic: Part Number Needed Please  (Read 852 times)

0 Members and 1 Guest are viewing this topic.

Sir Sideways

  • Intermediate Member
  • ***
  • Offline Offline
  • Gender: Male
  • Sideways in Staffordshire
  • Posts: 287
    • PFL 3.0 Auto Elite Estate
    • View Profile
Part Number Needed Please
« on: 08 March 2010, 20:25:13 »
I'm in need of an o ring that fits to the bottom of the air chamber box that sits on top of the plenum chamber. After removing it to change the cam gaskets, it was found to be perished and now its sucking in air.

So if someone has the part number, I would be very grateful.

Jim
Logged

Bumbazor

  • Senior Member
  • ****
  • Offline Offline
  • Gender: Male
  • Worksop
  • Posts: 515
    • View Profile
Re: Part Number Needed Please
« Reply #1 on: 08 March 2010, 20:28:17 »
Breather bridge to plenum seal - 90467543 

You might also need:
Breather bridge to throttle O ring (2) (4 on extended plenums) - 90500983
Logged
To do: Replace brake discs and pads; adjust already replaced shoes; check for leaks in oil cooler, cambelt area, crank seals, sump, dipstick; replace osf door; replace a tyre; clean, MOT.

Sir Sideways

  • Intermediate Member
  • ***
  • Offline Offline
  • Gender: Male
  • Sideways in Staffordshire
  • Posts: 287
    • PFL 3.0 Auto Elite Estate
    • View Profile
Re: Part Number Needed Please
« Reply #2 on: 08 March 2010, 20:48:25 »
Ta very muchly  :y
Logged

Bumbazor

  • Senior Member
  • ****
  • Offline Offline
  • Gender: Male
  • Worksop
  • Posts: 515
    • View Profile
Re: Part Number Needed Please
« Reply #3 on: 08 March 2010, 20:53:23 »
You're welcome.

Did you clean the breathers?
Logged
To do: Replace brake discs and pads; adjust already replaced shoes; check for leaks in oil cooler, cambelt area, crank seals, sump, dipstick; replace osf door; replace a tyre; clean, MOT.

PhilCavSRi130

  • Junior Member
  • **
  • Offline Offline
  • Gender: Male
  • Stone,  Staffordshire
  • Posts: 147
  • GRIFFIN POWER!!
    • View Profile
Re: Part Number Needed Please
« Reply #4 on: 09 March 2010, 20:36:08 »
Yes we did clean all the breathers out. TBH I was suprised how clean they were, when I cleaned mine out last year there was a lot more crud and crap came out of the breather set up.
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.009 seconds with 16 queries.