Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[cem_devecioglu]

just tried the new tb's today.still not starting,no faults,doesnt seem to be getting fuel,which 1 is fuel pump relay?? can it be checked or bypassed

did you have starting problems before  :-? , cause there is no starting problem mentioned in the post..

[Smooth]

The car was revving up for a while,then missing and backfiring,put on comp and tps faults showed,after a day the car would not start,put the new tb's on and still nothing... getting loads of fuel,no faults shown,done actuator tests on pump and tps,all good... car grinding and firing,keep grinding and it nearly goes... good compression etc,could it be the crank sensor... seen this before with no faults showing and it being that... am going mad here,tb's cost me 333 squid

[cem_devecioglu]

The car was revving up for a while,then missing and backfiring,put on comp and tps faults showed,after a day the car would not start,put the new tb's on and still nothing... getting loads of fuel,no faults shown,done actuator tests on pump and tps,all good... car grinding and firing,keep grinding and it nearly goes... good compression etc,could it be the crank sensor... seen this before with no faults showing and it being that... am going mad here,tb's cost me 333 squid

could be .. but dont rush..

did you have intermittent starting problems before ?

hesitation ?

[Smooth]

Never had any starting probs before,always on the button,cant understand it,does anyone know the ohm reading to check the sensor?? was looking thro autodata but it doesnt list it

[cem_devecioglu]

Never had any starting probs before,always on the button,cant understand it,does anyone know the ohm reading to check the sensor?? was looking thro autodata but it doesnt list it

I think you must see some other codes stored with p0200 and p220..  :-/


anyway, from some old info I know it can be tested with voltmeters.. let me check..

[cem_devecioglu]

here is some info
http://www.ehow.com/way_5471047_do-check-crankshaft-position-sensor.html

and another way to for checking it,

pass some ferrous metal very close crank sensor to it and check the voltage jump..

[Smooth]

Cheers mate,will check it tomorro...hopefully its handy to get at on my motor,have car sitting down at work but its too rather heavy to push on to a ramp by myself

[cem_devecioglu]

Cheers mate,will check it tomorro...hopefully its handy to get at on my motor,have car sitting down at work but its too rather heavy to push on to a ramp by myself

I hope you will sort it.. good luck..

and safety first.. 

[Smooth]

Where would you find the location of the sensor,any pics on the site?? not asking much am i

[cem_devecioglu]

Where would you find the location of the sensor,any pics on the site?? not asking much am i

in the passenger side close to the oil filter..

will add a picture..just a moment..

http://www.omegaowners.com/forum/YaBB.pl?num=1193589434

[jonnycool]

Where would you find the location of the sensor,any pics on the site?? not asking much am i

Have a look at this mate
http://www.omegaowners.com/forum/YaBB.pl?num=1174321688
Jon

[Smooth]

Thank you people,will try removing and cleaning tomorro,keep u all posted

[manny]

I had the same fault a while ago after i put cleaner down the bag pipes (air intake). It misfired and the revs were high.Maybe air mass meter?

[Smooth]

Just a quick update folks... went to check the cs sensor today and there was 2!! somebody replaced it before and just left the old 1 there,took out and cleaned,no difference,stripped of plenum again and checked everything... all ok... tried towing the car and it nearly started slightly... turned car over and started running but missing badly and backfiring like a wild bore on the job... next thing i disconnected something and the car run 100% and is going better now than ever before...
3 guesses to what it was...

a fart in a bottle to the first person who gets it right 

[jonny2112]

Just a quick update folks... went to check the cs sensor today and there was 2!! somebody replaced it before and just left the old 1 there,took out and cleaned,no difference,stripped of plenum again and checked everything... all ok... tried towing the car and it nearly started slightly... turned car over and started running but missing badly and backfiring like a wild bore on the job... next thing i disconnected something and the car run 100% and is going better now than ever before...
3 guesses to what it was...

a fart in a bottle to the first person who gets it right