Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[laughjimbo]

I have seen on the forum that you need a 13mm socket to adjust the seat height when the motor has got stuck. My motor is stuck but you can still hear it clicking but not moving the seat. I have tried a 13mm socket and it does not go anywhere near, are they all 13mm? I have tried 3/8 & 1/4 inch drive sockets but still too big. Any other suggestions on how to move the seat. It is stuck in the fully up position so can get access to everything ok.

Thanks in advance.


Laughjimbo

[mr ICE man]

It's pretty easy to do just pull your seat forward get in the back using a rag twist the thread understand the seat if you can reach press the button too as the will help to move it.so far has worked a treat on mine!hope it works!

[laughjimbo]

Thanks iceman will give that a try!!

laughjimbo

[laughjimbo]

I managed to get a 13mm 1/4" drive socket in the slot but i did give it a spray with WD40 first and then it just went in, turned the shaft and pulled out ok and now all works well.
Thanks for the help.

[Marks DTM Calib]

First port of call should always be the maintenace guide area....here you would have found this 

http://www.omegaowners.com/forum/YaBB.pl?num=1163236766

[seanjones]

Once again this site proves its considerable worth. Just what I was looking for.