Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to OOF

Pages: 1 [2]  All   Go Down

Author Topic: Rear Suspension - inner tyre wear - solution?  (Read 2535 times)

0 Members and 1 Guest are viewing this topic.

Vulpine

  • Junior Member
  • **
  • Offline Offline
  • Gender: Male
  • Kent UK
  • Posts: 137
  • Omega 2.5TD The Vegmega!!
    • Omega 2.5TD '97
    • View Profile
Re: Rear Suspension - inner tyre wear - solution?
« Reply #15 on: 04 July 2010, 21:21:02 »
hmmm they look in one piece each...
Logged
Admin edit

Richard A

  • Senior Member
  • ****
  • Offline Offline
  • Gender: Male
  • Aldridge, West Midlands
  • Posts: 865
    • View Profile
Re: Rear Suspension - inner tyre wear - solution?
« Reply #16 on: 04 July 2010, 22:03:27 »
As already said - Tony @ WIM Wheels in Motion.
Maybe a bit of a trip but worth every penny  :y
Give him a 'ring' with your 'readings', ask what he thinks.
regards
Richard a
Logged
richard a

feeutfo

  • Guest
Re: Rear Suspension - inner tyre wear - solution?
« Reply #17 on: 05 July 2010, 00:35:30 »
Quote
So if something is worn causing excessive camber at the rear, what could it be?
I have adjusted one tie bar right up, not much thread left but still the wheel looks excessively cambered!
Any ideas appreciated.... :(
Per chance is it being adjusted the wrong way?

And yes it is worth checking the springs are not broken off at the ends.

But FFS get it set up correctly or you'll be throwing tyres at it forever.
« Last Edit: 05 July 2010, 00:36:03 by chrisgixer »
Logged

feeutfo

  • Guest
Re: Rear Suspension - inner tyre wear - solution?
« Reply #18 on: 05 July 2010, 00:39:51 »
Quote
HaHaHa!!   somebody didn't read your location on your avatar, (Chris.............??)


bloody long round trip for a good tracking.................
;D sorry didn't quite catch what you said there Six, would you care to repeat that  ;D  ;)
Logged

TestOmega

  • Junior Member
  • **
  • Offline Offline
  • Gender: Male
  • Mississauga, Canada
  • Posts: 158
  • Been helped, will help.
    • View Profile
Re: Rear Suspension - inner tyre wear - solution?
« Reply #19 on: 05 July 2010, 02:15:53 »
Not the thread starter but mathewst from Croatia asked for information where it appeared you were directing them to a WIM centre in UK, you actually were not ... a bit of a trip that would have been from a guy in Croatia  ;)
« Last Edit: 05 July 2010, 02:54:20 by TestOmega »
Logged
!!!!!!!!!!!!!!!!!!  May I be blessed to give more than I receive  !!!!!!!!!!!!!!!!!!

Vulpine

  • Junior Member
  • **
  • Offline Offline
  • Gender: Male
  • Kent UK
  • Posts: 137
  • Omega 2.5TD The Vegmega!!
    • Omega 2.5TD '97
    • View Profile
Re: Rear Suspension - inner tyre wear - solution?
« Reply #20 on: 05 July 2010, 07:06:46 »
hmmm it looks logical from under the car that as the adjuster gets shorter, camber should reduce.
But I haven't tried the other direction. As soon as it stops being very hot, I will get under the car and give it a go. :P
Logged
Admin edit

kcl

  • Omega Knight
  • *****
  • Offline Offline
  • Gender: Male
  • Finland
  • Posts: 1224
    • Volvo V60 D4 -14
    • View Profile
Re: Rear Suspension - inner tyre wear - solution?
« Reply #21 on: 05 July 2010, 09:37:53 »
OP might have got something wrong: adjusting/turning tie rods will not affect camber, it adjusts toe. Camber is adjusted by opening the bolt/s on the strut...

I might be at the wrong end of the car though....  :-[ :-X
« Last Edit: 05 July 2010, 09:38:52 by kcl »
Logged

feeutfo

  • Guest
Re: Rear Suspension - inner tyre wear - solution?
« Reply #22 on: 05 July 2010, 09:40:24 »
Quote
OP might have got something wrong: adjusting/turning tie rods will not affect camber, it adjusts toe. Camber is adjusted by opening the bolt/s on the strut...

I might be at the wrong end of the car though....  :-[ :-X
think he's talking about the pass side rear?
Logged

feeutfo

  • Guest
Re: Rear Suspension - inner tyre wear - solution?
« Reply #23 on: 05 July 2010, 09:41:36 »
maybe use the opposite side thread length and wheel angle as a guide?
Logged

ffcgary1

  • Omega Baron
  • *****
  • Offline Offline
  • Gender: Male
  • Mitcham,Surrey.
  • Posts: 2805
  • I really must get my eyes seen to.
    • Omega Estate/ jaguar XJ6
    • View Profile
Re: Rear Suspension - inner tyre wear - solution?
« Reply #24 on: 05 July 2010, 23:53:05 »
vulpine dont waste your time mate, just take it to Tony at Wheels in Motion chesham bucks. have it set right first time. He will also give you a cracking deal on new rubber as well.  :y
Logged
Elite leather, cruise control, 3.0ltr cams, gas flowed 3.0ltr inlet manifold, 4 bar fuel pressure regulator, rear side window demisters, rear electric windows. projectors /HID'S, h/l washers.
Jaguar XJ6
Pages: 1 [2]  All   Go Up
« previous next »
 

Page created in 0.011 seconds with 17 queries.