Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please play nicely.  No one wants to listen/read a keyboard warriors rants....

Pages: [1]   Go Down

Author Topic: Poxy window won't shut.  (Read 489 times)

0 Members and 1 Guest are viewing this topic.

osealy

  • Intermediate Member
  • ***
  • Offline Offline
  • Gender: Male
  • dublin
  • Posts: 412
    • View Profile
Poxy window won't shut.
« on: 06 September 2010, 22:27:59 »
It goes up so far then drops a few inches, helping it by hand brings it up higher but it drops down again. Ideas?
Logged

Jinglemaster2

  • Guest
Re: Poxy window won't shut.
« Reply #1 on: 06 September 2010, 22:36:00 »
IIRC window motors have an object detection type set up. If the windo meets resistance, it asumes a hand is in the way and drives itself back down.

Omega usual problem is dry/dirty rails. squirt some oil or WD40 down the rubber runners and it should help. If the windo has started to raise at an angle, the door card needs to come off so you can access the mechanism and line everything up again.

Only cencellation is they are much better than Ford Galaxy ones.
Logged

Andy B

  • Get A Life!!
  • *****
  • Offline Offline
  • Gender: Male
  • Bury Lancs
  • Posts: 39738
    • ML350 TDM SmartRoadster
    • View Profile
Re: Poxy window won't shut.
« Reply #2 on: 06 September 2010, 22:36:05 »
Quote
It goes up so far then drops a few inches, helping it by hand brings it up higher but it drops down again. Ideas?

The window is tightin its runners, so the anti-trap is opperating. Lub the runners. Taylors chalk has recently been sugested but most use silicon spray.  :y :y
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.009 seconds with 16 queries.